Справочник Пользователя для Avaya 03-300430

1033

FAIL

The EI circuit pack under test cannot make contact with its neighbor EI or 

SNI circuit pack.
Perform the 

in Maintenance Procedures (03-300192).

2027

FAIL

The EI circuit pack has contact with the neighboring EI or SNI circuit pack, 
but it is the incorrect EI or SNI circuit pack.

1. Enter list fiber-link and verify that every fiber link cable is 

installed as it is administered.

2. Repeat the command.

PASS

The EI circuit pack has successfully established a link with the neighbor EI 

or SNI circuit pack.
If status port-network still indicates that this link is down, one or both 

of the EI and/or SNI circuit packs may have been busied out.

1. If the link still does not come up, reset one or both EI and/or SNI circuit 

packs on the link.

0

NO 

BOARD

No board was detected by the test.

1. Check the error log for wrong board (Error 125) or no board (error 

131). Resolve either of these issues, if applicable.

2. Check that the board is properly translated and inserted. If so, check 

for hyperactivity (Error 1538). If hyperactive, use reset board 
location.

3. Run the test again. If it fails, the ID chip on board may be bad. Replace 

the board and retest.

 2 of 2