Справочник Пользователя для Desa CGD3924NR
21
103343
OPERATING
HEATER
Continued
TO TURN OFF GAS TO APPLIANCE
Shutting Off Heater
1. Turn control knob clockwise
to the OFF position.
2. Set remote selector switch in the OFF position to keep from draining battery.
Shutting Off Burners Only (pilot stays lit)
You may shut off the burners and keep the pilot lit by doing one of the following:
• Turn control knob clockwise
to the PILOT position.
• Use remote control manual OFF button.
• Set remote selector switch in the OFF position.
• Set remote selector switch in the OFF position.
THERMOSTAT CONTROL OPERATION
The thermostat control setting on the remote control unit can be set to any comfort level
between HI and LO. The Burners will turn on and off automatically to maintain the
comfort level you select. The ideal comfort setting will vary by household depending
upon the amount of space to be heated, the output of the central heating system, etc.
between HI and LO. The Burners will turn on and off automatically to maintain the
comfort level you select. The ideal comfort setting will vary by household depending
upon the amount of space to be heated, the output of the central heating system, etc.
MANUAL LIGHTING PROCEDURE
1. Follow steps 1 through 6 under Lighting Instructions, pages 19 and 20.
2. Depress control knob and light pilot with match.
3. Keep control knob pressed in for 30 seconds after lighting pilot. After 30 seconds,
release control knob. Now follow step 9, page 20.
Figure 21 - Setting the Remote Selector Switch, Control Knob, and Flame
Adjustment Knob for Remote Operation
ON
OFF
REMOTE
OFF
REMOTE
O
FF
PILO
T
O
N
L O
I H
Remote Selector Switch in Remote Position
Control Knob in On Position
Flame Adjustment Knob
1. After lighting, let pilot flame burn for about one minute. Turn control knob to ON
position. Adjust flame adjustment knob anywhere between HI and LO. Slide the
remote selector switch to the REMOTE position.
remote selector switch to the REMOTE position.
The burners will come on. You
can now turn the burners on and off with the hand-held remote control unit.
IMPORTANT:
Do not leave the remote selector switch in the REMOTE position
when the pilot is not lit. This will drain the battery.
2. Select the MANUAL or AUTO button on the hand-held remote control unit.
• In MANUAL mode, turn burners on or off by pressing the ON or OFF buttons
on the hand-held remote control unit.
• In AUTO mode, the room temperature is controlled by the thermostat in the
hand-held remote control unit. To increase the room temperature, press the top
arrow of the TEMP button. To lower room the temperature, press the bottom
arrow to the TEMP button. At higher settings the heater will run more.
arrow of the TEMP button. To lower room the temperature, press the bottom
arrow to the TEMP button. At higher settings the heater will run more.
IMPORTANT:
The hand-held remote control unit must be near the heater. Do not
keep the hand-held remote control unit too close the heater. The thermostat on
the hand-held remote control unit will heat up too quickly and turn the heater
off.
the hand-held remote control unit will heat up too quickly and turn the heater
off.
HAND HELD REMOTE OPERATION
NOTICE
You must light the pilot before using the hand-held remote control unit. See
Lighting Instructions on page 19.
Lighting Instructions on page 19.
Continued