Листовка для Insignia NS-FANT12-CH

Safety 
screw

Front guard

Rear guard

Blade 

cap

Guard knob

Fan blade

Handle

Oscillation 

knob

Lock

Fan blade 

stem

Tilt knob

Stand

Motor housing 
(assembled)

Power knob

Power cord

Base

Pole locking cap

Motor shaft

Blade cap

Guard knob

Fan blade

Rear guard

Motor housing (assembled)

Base

Pole locking cap

Front guard

Safety screw

Fan blade 
stem

Quick Setup Guide

Before using your new product, please read these instructions to prevent any damage.

1  Remove the pole locking cap from the stand, then remove the blade 

cap and guard knob from the motor shaft.

2  Slide the stand into the hole at the center of the base, then tighten 

the pole locking cap underneath the base.

12" table fan includes:

•  Four metal blades
•  Oscillating head with adjustable angle tilt
• 3-speed settings
• Fused safety plug

3  Slide the back guard onto the motor shaft, then screw the guard knob 

on to hold it in place. Make sure that the handle is at the top.

4  Put the fan blade on the motor shaft, then screw the blade cap on to 

hold it in place. Make sure that the stem of the fan blade is closest to 
the motor housing.

5  Align the screw holes in the front and back guards with each other, 

then close the four locks to hold the guards together. 

Tip: The screw holes are at the bottom of the guards.