Справочник Пользователя для Monte Carlo Fan Company 5OBR52
Loosen 2 screws with slots, remove
one screw and place plate over holes
and twist into place. Replace the
screw removed and tighten all screws
securely.
28
Loosen 2 screws and remove 1
screw to allow bottom fan plate to
be installed. If attaching light kit skip
to step 28.
24
Install lower cover plate over loos-
ened screws and twist lower cover
plate with key hole slots into place.
If not using light kit push wires up
and tighen all 6 screws securely.
26
Tighten all 3 screws securely.
Attach blade arms to blades using
the blade arm screws and washers
provided.
20
22
Check the motor for plastic shipping sta-
bilizer tabs and remove if they are pres-
ent. The screws, washers and motor pads
are pre-installed to the blade holders.
Attach blade assembly to motor and
tighten screws securely.
23
Place floating brackets onto blades
aligning holes in blade with the float-
ing bracket.
Attach center cover plate by screw-
ing into center of fan
21
27
Loosen 2 screws and remove 1 screw
on light kit cover.
Plug white wire from fan to white
wire from light kit. Then plug black
wire from fan to black wire from light
kit.
29
30
Take plate with glass and place over
the 2 screws and twist to hold in
place. Replace screw removed.
19
Remove the 3 screws holding plates
together if not using light kit, to
seperate lower cover plate from light
plate.
25