Справочник Пользователя для Mitsubishi Electronics PAR-U02MEDA

– 1 –

This installation manual describes how to install the Smart ME Controller for use with Mitsubishi 
Building Air Conditioning System, direct expansion type CITY MULTI air conditioner indoor units (“-A” 
type and later). 
Please be sure to read this installation manual and Instruction Book that are supplied with the Remote 
Controller before proceeding with the installation. Failure to follow the instructions may result in 
equipment damage.
For information on how to wire and install the air conditioning units, refer to the Air Conditioner 
Installation Manual. 
After the installation, hand over this manual to users.
Smart ME Controller is a type of ME Remote Controllers, sometimes simply referred to as ME Remote 
Controller.

• Read the following safety precautions prior to installation.
• Observe these precautions carefully to ensure safety.

• After reading this manual, pass it on to the end user to retain for future reference.
• Keep this manual for future reference and refer to it as necessary. This manual should be made 

available to those who repair or relocate the controller. Make sure that the manual is passed on to 
any future users.

 

Indicates a risk of death or serious injury.

Indicates a risk of serious injury or structural damage.

Do not install the unit in a place where large amounts of 
oil, steam, organic solvents, or corrosive gases, such 
as sulfuric gas, are present or where acidic/alkaline 
solutions or sprays are used frequently. These 
substances can compromise the performance of the 
unit or cause certain components of the unit to corrode, 
which can result in electric shock, malfunctions, 
smoke, or fire.

To reduce the risk of shorting, current leakage, electric 
shock, malfunctions, smoke, or fire, do not wash the 
controller with water or any other liquid.

To reduce the risk of electric shock, malfunctions, 
smoke or fire, do not operate the switches or touch 
other electrical parts with wet hands.

To reduce the risk of injury or electric shock, before 
spraying a chemical around the controller, stop the 
operation and cover the controller.

To reduce the risk of injury or electric shock, stop the 
operation and switch off the power supply before 
cleaning, maintaining, or inspecting the controller.

Properly install all required covers to keep moisture 
and dust out of the controller. Dust accumulation and 
water can cause electric shock, smoke, or fire.

To reduce the risk of injury, keep children away while 
installing, inspecting, or repairing the controller.

WT06829X02.book  Page 1  Wednesday, June 26, 2013  4:03 PM