Справочник Пользователя для Tecumseh LV156EA
181-1215-14
Four-Cycle Engine • Vertical Crankshaft • Air-Cooled
Page 7
V. Starting Your Engine
To avoid serious injury or death, an
adult should start this engine. Only
adult should start this engine. Only
allow children to start engine if an adult has determined
they are experienced and capable of such operation.
they are experienced and capable of such operation.
If you are unable to start this engine
after following instructions in this
after following instructions in this
manual, contact your Authorized TecumsehPower
Servicing Dealer. To avoid serious burn injuries or damage
to your engine, DO NOT attempt to start or troubleshoot
this engine in any other way. For example:
Servicing Dealer. To avoid serious burn injuries or damage
to your engine, DO NOT attempt to start or troubleshoot
this engine in any other way. For example:
• DO NOT use starting fluid.
• DO NOT spray flammable vapors into carburetor or
onto air cleaner.
• DO NOT put flammable liquids into carburetor or
onto air cleaner.
• DO NOT operate engine or pull on starter rope with
spark plug removed. Fuel can spray from spark plug
hole and ignite.
hole and ignite.
This section contains starting instructions for several
different types of engines. In order to locate the instructions
that apply to your engine, first determine what type of starter
you have. If you have an electric starter, see "A. Engines
with Electric Starters" instructions. If you have a manual
recoil starter, see "B. Engines with Recoil Starters"
instructions on page 10.
different types of engines. In order to locate the instructions
that apply to your engine, first determine what type of starter
you have. If you have an electric starter, see "A. Engines
with Electric Starters" instructions. If you have a manual
recoil starter, see "B. Engines with Recoil Starters"
instructions on page 10.
A. Engines with Electric Starters
Only one of the following three sections will apply to your
engine. See Table 3.
engine. See Table 3.
I.
Primer Bulb Only
1.
To avoid carbon monoxide poisoning, be sure engine is
outdoors in a well-ventilated area.
outdoors in a well-ventilated area.
2.
Move engine throttle control to “FAST” position, if
present (see equipment manufacturer’s instructions).
See Figures 12 and 13.
present (see equipment manufacturer’s instructions).
See Figures 12 and 13.
3.
When starting a cold engine, press primer bulb firmly 3
times, allowing primer bulb to return completely to orig-
inal position between pushes. See Figures 14 and 15.
Afterward, continue reading instructions below.
times, allowing primer bulb to return completely to orig-
inal position between pushes. See Figures 14 and 15.
Afterward, continue reading instructions below.
NOTES
Be sure to cover vent hole when pressing primer bulb.
See Figure 14.
See Figure 14.
Cooler temperatures may require pushing primer bulb firmly
5 times.
5 times.
DO NOT use primer to restart a warm engine after a short
shutdown. Doing so will flood the engine and may result in
equipment malfunction.
shutdown. Doing so will flood the engine and may result in
equipment malfunction.
4.
Operate equipment control to release engine brake or
clutch, if present (see equipment manufacturer’s
instructions). See Figure 12.
clutch, if present (see equipment manufacturer’s
instructions). See Figure 12.
Table 3. Engines with Electric Starters
WARNING
WARNING
WARNING
WARNING
If your engine has:
Go to:
Primer Bulb Only
Section A.I
Choke Only
Section A.II
Primer Bulb and Choke
Section A.III
Figure 12. Typical Engine Controls
Figure 13. Typical Engine Symbols
Figure 14. Pressing Primer Bulb
1. Electric Start Switch
2. Engine Throttle Control
3. Equipment Control
1
3
2
STOP
STOP
SLOW
RUN
FAST CHOKE PRIMER
1. Primer Bulb
2. Vent Hole
1
2