Справочник Пользователя для Heath Zenith 6153/62/71/72
-2-
595-5611-07
6. Mount push button. Use either screws or double
sided tape to mount push button.
•
•
Screw Mounting: To mount with screws, remove
back of case by pushing in tab on bottom with a small
screwdriver (see Figure 1). Note: Remove material in
screw holes (if needed) before mounting with screws.
Attach back of case to door jamb or wall (see Figure
4). Snap front of push button on.
back of case by pushing in tab on bottom with a small
screwdriver (see Figure 1). Note: Remove material in
screw holes (if needed) before mounting with screws.
Attach back of case to door jamb or wall (see Figure
4). Snap front of push button on.
•
Tape Mounting: When attaching push button using
double sided tape, make sure the surface of the door
jamb or wall is clean.
double sided tape, make sure the surface of the door
jamb or wall is clean.
7. Mount chime. Chime can be mounted by using 3
holes in the back of case, or by using 2 screws with
keyholes.
keyholes.
Keyhole Mounting: Determine mounting location.
• Mark two hole locations. Note: Make sure holes are level before drilling.
• Mark two hole locations. Note: Make sure holes are level before drilling.
• Models 6153 and 6162 (see Figure 5): 3-5/16" (8.4 cm) apart.
• Models 6171 and 6172 (see Figure 5): 2-3/8" (6 cm) apart.
• Models 6171 and 6172 (see Figure 5): 2-3/8" (6 cm) apart.
• Drill two 7/32" diameter pilot holes for wall anchors and insert anchors.
• Mount keyhole screws to wall leaving about 1/8" (3 mm) of the screw threads
• Mount keyhole screws to wall leaving about 1/8" (3 mm) of the screw threads
exposed.
• Snap cover onto chime base.
• Models 6153 and 6162: Align top edge of case with top of back plate. Rotate
bottom of case toward back plate and snap into position (see Figure 7).
• Models 6171 and 6172: Align bottom edge of case with bottom of back
plate. Rotate top of case toward back plate and snap into position (see
Figure 7).
Figure 7).
• Using keyholes on back of chime base, hang base on screws (see Figure 5).
Screw Mounting: Determine mounting location.
• Place chime against wall and verify the chime is level.
• Use chime holes as a template (see Figure 6). Drill three 7/32" diameter pilot
Screw Mounting: Determine mounting location.
• Place chime against wall and verify the chime is level.
• Use chime holes as a template (see Figure 6). Drill three 7/32" diameter pilot
holes for wall anchors (provided) and insert anchors.
• Insert 3 screws (provided) through holes in back of chime.
• Verify chime is level and tighten screws securely.
• Snap cover onto chime base.
• Verify chime is level and tighten screws securely.
• Snap cover onto chime base.
• Models 6153 and 6162: Align top edge of case with top of back plate. Rotate
bottom of case toward back plate and snap into position (see Figure 7).
• Models 6171 and 6172: Align bottom edge of case with bottom of back
plate. Rotate top of case toward back plate and snap into position (see
Figure 7).
Figure 7).
Figure 4