Справочник Пользователя для Allstar Products Group 3500

15 

The following instructions detail installation of Allstar Model  9931 Radio Controls.   For other Radio models, see instructions 
packaged with product.  

Setting The Coding Switches:  When setting the Coding Switches THE FACTORY PRE-SET CODES MUST BE CHANGED TO 
PREVENT UNAUTHORIZED OPERATION. Transmitter and Receiver codes must be set IDENTICALLY.  If just one Code Switch 
is mismatched, the Radio Controls will not function.  

NOTE:  For security reasons, it is advisable NOT to set all the switches in the same position.  

Mounting The Receiver:  After setting the 
Coding Switches, mount the  Receiver on 
the rear panel of the Opener by connecting 
it to Terminals  1, 2 and 3.  A small Plastic 
Pin is provided to secure the other end of 
the  Receiver to the panel.  For proper 
operation, the Antenna Wire should  be 
POINTED STRAIGHT DOWN toward 
the floor.   
 
After installing the Radio Controls, check 
their operation by moving  approximately 
35 FT away from the garage door and 

pressing the  Transmitter Button.  Operation at this distance should be reliable.    
 
If the Transmitter  doesn't activate door operation, check that all Coding Switches are set 
identically.  If the operational distance is inadequate,  try moving the position of the 
Transmitter in the car.  If the distance is still  inadequate, try bending the Antenna Wire to 
a different angle.  If the distance is still inadequate, replace the Battery with a standard 9-
Volt “transistor radio” Battery (NEDA 1604).  The Battery is located in the front 
compartment next to the Coding Switches. 
The Transmitter may be hand held if desired by removing the Visor Clip from the rear of 
the Case as illustrated.   Place your finger in the loop at the top of the visor, and your 
thumb on the top edge of the Transmitter.  Push down with your thumb and pull up with 
your finger.  Clip will release and pull out easily. 

TRANSMITTER:  To gain access to the 
Transmitter Coding Switches, remove the 
Battery Cover from the front of the 
Transmitter by sliding it toward the 
bottom of the Transmitter as  illustrated. 

RECEIVER:   The Receiver Coding 
Switches can be accessed by removing 
the small door from the back of the 
Receiver using a small screwdriver or 
knife. 

CODING BLOCK:  Transmitter  and 
Receiver Coding Switches  are contained 
in identical Coding Blocks, consisting of  
nine small switches, labeled 1 - 9, each of 
which can be set in any of three positions, 
labeled +, 0, -  

104384 

104385 

104386 

104387 

104388