Справочник Пользователя для Vermont Casting DV360

52

This gas fireplace should be installed by a qualified in-
staller in accordance with local building codes, and with 
current CSA-B149.1 Installation codes for Gas Burning 
Fireplaces and Equipment, and CAN/ 
CSA Z 240.4 Canada.
A manufactured home (US only) or mobile home 
OEM installation must conform with the Manufactured 
Home Construction and Safety Standard, Title 24 CFR 
Part 3280, or when such a standard is not applicable, 
the Standard for Manufactured Home Installations
ANSI/NCSBCS A225.1, or Standard for Gas Equipped 
Recreational Vehicles and Mobile Housing
CSA Z240.4.
The appliance when installed, must be electrically 
grounded in accordance with local codes or, in the ab-
sence of local codes, with the current National Electri-
cal Code, ANSI/NFPA 70, or the Canadian Electrical 
Code, CSA C22.1.
FOR SAFE INSTALLATION AND OPERATION 
PLEASE NOTE THE FOLLOWING: 
1.  This fireplace gives off high temperatures and 

should be located out of high traffic areas and away 
from furniture and draperies.

2.  Children and adults should be alerted to the hazards 

of fireplace high surface temperatures and should 
stay away to avoid burns or ignition of clothing.

3.  Children should be carefully supervised when in the 

same room as your fireplace.

4.  Under no circumstances should this fireplace be 

modified. Parts removed for servicing should be 
replaced prior to operating this fireplace again.

5.  Installation and any repairs to fireplace should be 

performed by qualified installer, service agency or 
gas supplier. A professional service person should 
be contacted to inspect fireplace annually. More 
frequent cleaning may be required due to excess lint 
and dust from carpeting, bedding material, etc.

6.  Control compartments, burners and air passages 

in this fireplace should be kept clean and free of 
dust and lint. Make sure that the gas valve and pilot 
light are turned off before you attempt to clean this 
fireplace.

7.  The venting system (chimney) of this fireplace 

should be checked at least once a year and if 
needed your venting system should be cleaned.

8.  Keep the area around your fireplace clear of com-

bustible materials, gasoline and other flammable 
vapor and liquids. This fireplace should not be used 
as a drying rack for clothing, nor should Christmas 
stockings or decorations be hung on or around the 
fireplace.

9.  Under no circumstances should any solid fuels 

(wood, coal, paper or cardboard etc.) be used in this 
fireplace.

10. The flow of combustion and ventilation air must not 

be obstructed in any way.

11. When the fireplace is installed directly on carpet-

ing, vinyl tile or any combustible material other than 
wood, the fireplace must be installed on a metal or 
wood panel extending the full width and depth of the 
fireplace.

12. This fireplace requires adequate ventilation and 

combustion air to operate properly.  

1.  Discount power to unit and shut off the gas supply.
2.  Remove the window frame assembly (see ‘Window 

Frame Assembly’ section).

3.  Carefully remove the logs.
4.  Remove the pilot assembly from bracket.
5.  Remove the screws which are holding the burner 

housing assembly in place.

6.  Remove the burner housing assembly.
7.  Remove the main and front orifice and replace with 

the orifice supplied in the conversion kit. Use the 
small orifice size for the front burner and the bigger 
orifice size for the main burner.

8.  Remove the compression fitting which holds the alu-

minium tubing in the pilot assembly. This will reveal 
the pilot orifice which must be replaced with the one 
provided in the conversion kit.

9a. Units with SIT valve (Refer to illustrations in the 

installation instructions supplied with the kit):