Справочник Пользователя для Sony 900
7
Chapter 7 Location and Function of Parts and Controls
85
HDC-900/950/930 Series Product Information Manual
e
TRACKER connector (20-pin)
Used for communication between the camera operator
and tracker and for intercom 1 and 2 connection. This
also supplied the up tally and program audio signals.
The TRUNK LINE input/output signals are also
assigned.
and tracker and for intercom 1 and 2 connection. This
also supplied the up tally and program audio signals.
The TRUNK LINE input/output signals are also
assigned.
f
GENLOCK IN/RET IN/PROMPTER OUT (external
gen-lock signal input/return video signal input/
prompter signal output) connector (BNC type)
and switch
gen-lock signal input/return video signal input/
prompter signal output) connector (BNC type)
and switch
Set the switch according to the signal at the connector.
GENLOCK IN
: For input of an external gen-lock signal
(valid in stand-alone use only)
RET IN
: For input of the return video signal (valid in
stand-alone use only)
PROMPTER OUT
: Used for output of a prompter
signal (valid only when a camera control unit is
connected)
connected)
g
AUDIO IN (audio input 1, 2) connectors (BNC
type) and switches
type) and switches
Connect audio signals. An input select switch and
microphone power switch are provided for each
channel.
microphone power switch are provided for each
channel.
A Input select switch: Set to the appropriate
position according to the connected equipment.
LINE
: When a line-level signal source is
connected
MIC
: When a microphone is connected
B Microphone power switch:
When a microphone is connected, set whether
or not to supply power to the microphone.
or not to supply power to the microphone.
+48V
: To supply a power of +48 V
OFF
: Not to supply a power
Note
To supply a power of +12 V, modification of the camera
is required. For details, refer to the Installation &
Maintenance Manual. Note that the modification must
be performed by service personnel only.
is required. For details, refer to the Installation &
Maintenance Manual. Note that the modification must
be performed by service personnel only.
h
RET CONT (return control) connector (6-pin)
Used for connection to a CAC-6 Return Video Selector.
i
EXT I/O (external input and output) connector
(20-pin)
(20-pin)
Used to supply signals, such as Y/Pb/Pr signals, to
external equipment.
external equipment.
j
REMOTE connector (8-pin)
Used for connection to an RM-B150 Remote Control
Unit, RCP-700-series Remote Control Panel or MSU-
700A/750 Master Setup Unit.
Unit, RCP-700-series Remote Control Panel or MSU-
700A/750 Master Setup Unit.
k
DC OUT (DC power supply output) connector (4-
pin)
pin)
Used to supply power to devices such as a wireless
receiver (optional).
receiver (optional).
l
DC IN (DC power supply input) connector (XLR
4-pin)
4-pin)
Used for connection to the AC-550/550CE AC
Adaptor, a battery etc. to supply power to the camera.
Adaptor, a battery etc. to supply power to the camera.
m
HD SERIAL OUT connector (BNC type)
Used for output of HD SDI serial data.
n
VTR connector (26-pin)
Used for connection to a VTR (such as the HDW-250)
or HDCD-50 HD Signal Distributor.
or HDCD-50 HD Signal Distributor.
LINE MIC
OFF+48V
AUDIO
CH-1
IN
LINE MIC
OFF+48V
CH-1
1
Input select switches
2
Microphone power switches