Справочник Пользователя для Vermont Casting 20DVT
10009459
17
Brookhaven Direct Vent Gas Fireplace
Glass Information
Only glass approved by CFM Corporation
should be used on this fireplace.
should be used on this fireplace.
•
The use of any non-approved replacement glass will
void all product warranties.
void all product warranties.
•
Care must be taken to avoid breakage of the glass.
•
Do not operate appliance with glass front
removed, cracked or broken.
removed, cracked or broken.
•
Replacement glass (complete with gasket and
window frame) is available through your CFM
Corporation dealer and should only be installed
by a licensed qualified service person.
window frame) is available through your CFM
Corporation dealer and should only be installed
by a licensed qualified service person.
Operating Instructions
Cast Front Panel
Attach the cast
panel by hook-
ing onto top of
fireplace.
panel by hook-
ing onto top of
fireplace.
To remove the
cast front assem-
bly, pull cast front
up then lift out.
cast front assem-
bly, pull cast front
up then lift out.
Glass Cleaning
It is necessary to clean the glass periodically. During
start-up condensation, which is normal, forms on the
inside of the glass and causes lint, dust and other
airborne particles to cling to the glass surface. Also
initial paint curing may deposit a slight film on the glass.
It is therefore recommended the glass be cleaned
two or three times with a non-ammonia household
cleaner and warm water (gas fireplace glass cleaner
is recommended). After the initial cleaning process the
glass should be cleaned two or three times during each
operating season depending on the environment in the
house.
start-up condensation, which is normal, forms on the
inside of the glass and causes lint, dust and other
airborne particles to cling to the glass surface. Also
initial paint curing may deposit a slight film on the glass.
It is therefore recommended the glass be cleaned
two or three times with a non-ammonia household
cleaner and warm water (gas fireplace glass cleaner
is recommended). After the initial cleaning process the
glass should be cleaned two or three times during each
operating season depending on the environment in the
house.
Clean the glass after the first two weeks of
operation.
Do not clean glass when hot.
Do not use abrasive cleaners.
Do not strike or slam the glass.
operation.
Do not clean glass when hot.
Do not use abrasive cleaners.
Do not strike or slam the glass.
FP1628
Cast front assy
5/06
Cast front assy
5/06
Cast Front
FP1628
Fig. 29 Remove
cast front by lifting
up then out.
cast front by lifting
up then out.
Window Frame Assembly Removal
1. Turn the fireplace OFF (including the pilot).
2. If the unit has been operating, allow time for the
2. If the unit has been operating, allow time for the
components to cool.
3. Remove cast front assembly.
4. Unlock the frame window by removing the two (2)
4. Unlock the frame window by removing the two (2)
machine screws at the top corners of the window
frame.
frame.
5. Unlock the frame window by pulling the handle of the
two latches at the bottom part of the window frame.
Pull the left latch counterclockwise and the right
latch clockwise.
Pull the left latch counterclockwise and the right
latch clockwise.
6. Pull the bottom of the glass frame assembly out and
slide the top of the frame assembly out the slot at
the top.
the top.
7. To replace the window frame assembly, reverse this
procedure.
������
�����������������
����
�����������������
����
Machine
Screw
Machine
Screw
Pull Left
Side Latch
Counter-
clockwise
Pull Right
Side Latch
Clockwise
FP1629
Fig. 30 Window frame assembly removal.