Справочник Пользователя для Majestic Appliances 360DVS2

33

To  convert this appliance from gas type to another, fol-

low these instructions. Before proceeding, turn control 

knob to “OFF” and turn gas supply OFF. Turn OFF any 

electricity that may be going to the appliance.
CAUTION: Logs may be HOT! Allow to cool before 

1.  Disconnect power to unit and shut off the gas supply.
2.  Remove window frame assembly (see “Window 

Frame Assembly Removal” Section).

3.  Carefully remove the logs and lava rock material.
4.  Remove the screws holding the burner housing as-

sembly in place.

5.  Remove the burner housing assembly. On some 

models you may need to loosen the pilot bracket 

retaining screw/nut, and tilt the pilot and bracket 

assembly to gain sufficient clearance to remove the 

burner housing assembly.

6.  Remove front and rear orifice and replace with  

orifice supplied in the conversion kit. 

  NOTE: On 360DV/S2/S3/SL/SR, both burner orifices 

are the same size. 

7.  Remove the screws holding the air shutter to the 

burner tubes. (Fig. 47) Note the alignment of the air 
shutter on the tubes. Remove the air caps and re-
place them with the new air shutters supplied in the 
conversion kit.

FP1447

360DVS

air shutter

Air Shutter Retain-

ing Screws

Air Shutters

FP1447

Fig. 47  Air shutter adjustment.

8.  SIT Top Convertible Pilot 
  Gently lift off pilot hood from the pilot. NOTE:  Do not 

remove the spring clip holding the hood in place. Us-
ing a correctly-sized Allen key, unscrew the exposed 
orifice. Insert the new orifice supplied in the kit; do 
not overtighten the orifice. Replace the pilot hood 
ensuring the index tab aligns with the notch on the 
hood.

  PSE Pilot
  Using a suitable wrench on hexagonal body, un-

screw the pilot hood assembly from the pilot. Do not 
twist the hood itself. Remove the orifice and replace 
it with the new orifice supplied in the kit. Refit the pi-
lot hood assembly. Do not overtighten the pilot hood. 
The hood must return to its original alignment. Take 
care not to damage the thermocouple, thermopile or 
igniter.

9.  SIT 820 NOVA Gas Control Valve (Fig. 48)
  a) Using a Torx T20 or slotted screwdriver, remove 

and save three (3) pressure regulator mounting 
screws (A), pressure regulator tower (B), and dia-
phragm (C). 

  b) Ensure the rubber gasket (D) is properly posi-

tioned and install the new HI/LO pressure regulator 
to the valve using the new screws (E) supplied with 
the kit. Tighten the screws securely. (Reference 
torque:  25 in.lb.) 

  c) Install the enclosed identification label (F) to the 

valve body where it can be easily seen. 

FC107

SIT820

valve conversion

10/03   

A

B

C

OFF

PILO

T

ON

FC107

Fig. 48  Remove mounting screws, pressure regulator tower 
and diaphragm assembly.