Справочник Пользователя для Regency P33-NG3

Regency P33-3 Zero Clearance Direct Vent Gas Fireplace

A wall thermostat may be installed if desired, 
connect the wires as per the wiring diagram. 
Use table below to determine the maximum 
wire length.

Regency offers an optional programmable 
thermostat but any 250-750 millivolt rated non-
anticipator type thermostat that is CSA, ULC or 
UL approved may be used.

Use the Regency Remote Control Kit  approved 
for this unit. Use of other systems may void 
your warranty.

The remote control kit comes with a hand 
held transmitter, a receiver and a wall mount-
ing plate.

1)  Choose a convenient location on the wall 

to install the receiver and the receptacle 
box (protection from extreme heat is very 
important). Run wires from the fi replace to 
that location. Use Thermostat Wire Table.

2)  Connect the two wires to the gas valve. 

See diagram below.

3)  Install 3 AAA alkaline batteries in transmitter 

and 4 AA alkaline batteries in  the receiver. 
Install the receiver and its cover in the wall. 
Switch the  remote receiver to "remote" 
mode. The remote control is now ready for 
operation.

1)  Run the supplied 15' of wire through the right 

or left side gas inlet opening. Be careful not 
to damage wire.

2)  Connect the wire to the supplied wall switch 

and install into the receptacle box.

14 GA.
16 GA.
18 GA.
20 GA.
22 GA.

50 Ft.
32 Ft.
20 Ft.
12 Ft.

9 Ft.

Wire Size                       Max. Length