Справочник Пользователя для Regency I3100L

Regency Wood Insert & Hearth Heater

9

1)  Slide the spring nuts (supplied) over the 

slots in the insert’s side convection panels 
(the spring nuts may need to be squeezed 
with a pair of pliers fi rst, to help them stay 
in position).

2)  Screw the side faceplate panels, (item A in 

Diagram 4) one to each side.

3)  Using the top panel (item B in the diagram) 

as a gauge, check that the side panels are 
within approximately 1/4" of the overall width. 
If the difference is greater than this, use 
the supplied washers to attain the required 
width.  

The unit may now be slid into fi nal position and 
attached to the connection system.

Once connection is made, the insulation strips 
should be installed between the insert faceplates 
and the fi replace face. The faceplate top may 
now be installed (with insulation strip behind) 
by aligning its brackets with the top fl ange on 
the side shields and the angle iron bar on the 
insert top.  The faceplate trim may be installed 
to the edge of the faceplate at this time.

I1100S: Drill two 5/32" diameter holes through 
the trim and side panels and screw the trim to the 
panels using the gold plated screws provided.

Now that your insert is installed, check once 
more that all the clearances from the unit to 
any combustible materials are correct as listed 
earlier.

6)  Once the above items have been checked, 

slide your insert into position after fi rst po-
sitioning the fl ue liner and offset if required. 
(Re-install raincap at completion of installa-
tion).

Prior to sliding your insert into its fi nal position 
and attaching the connector or liner pipe, the 
faceplate side panel plates must be installed 
as follows:

1)  Fasten the faceplate mounting bracket to the 

side of the insert (one on each side) using 
the screws provided (2 screws per bracket) 
(refer to Diagram 1).

2)  Assemble the faceplate sides and top with 

4 screws (see Diagram 2).

3)  Attach the assembled faceplate to the 

faceplate mounting brackets.

4)  If the fl oor of your fi replace is below the 

level of the fi replace opening, adjust the 
insert's levelling bolts to accommodate the 
difference. When additional shimming is 
required, use non-combustible masonry or 
steel shims.

5)  Measure approximately the alignment of 

the fl ue liner with the position of the smoke 
outlet hole on the insert to check for pos-
sible offset. If an offset is required, use a 
proper stainless steel unit available with 
the chimney liner.