Справочник Пользователя для Majestic Appliances 3100

m

Vermont Castings Jefferson Vent Free Gas Heater

1. Attach the fan to the rear shroud by engaging the
upper flange of the fan skirt under the lower edge of the
shroud and secure the skirt with the four screws and
one star washer provided. (Fig. 8, 9 )

2. Disconnect the snapstat module from the leads
inside the snapstat bracket. (Fig. 10)

3. Bend open the snapstat bracket. use your fingers or
needle nose pliers to remove the black plastic grommet
from the bracket. Discard the grommet and bracket.

4. Secure the snapstat to the upper middle of the inner
shroud. (Fig. 11) NOTE: The snapstat location may be
reached through the front of the stove between the top
and the firebox or you may loosen the four screws
holding the rear shroud in place. Be sure to secure
shroud back into place before operation.

5. Connect the two wires to the two snapstat extension
leads attached to the inner shroud. You may coil excess
wire up inside the rear shroud.

6. Route the rheostat control switch and wire forward
under the stove. (Fig. 12) Use the wire tie to secure the
fan and rheostat wire harnesses together to the tubing
under the heater.

ST241

Fig. 9  Correct position of fan skirt installation.

ST347a

Fig. 12   Attach rheostat to control panel. Valve may look
different.

Rheostat

Retaining Nut

Control Knob

Pinch Grommet
to Remove

Snapstat
Bracket

Snapstat
Module

ST468

Fig. 10  Remove snaptstat and grommet from bracket.

ST346a

Fig. 11  Attach snapstat to inner shroud.

Snapstat

Upper
Flange

To Control
Valve

ST240

Fig. 8  Place upper flange behind lower edge of shroud.

Star Washer