Справочник Пользователя для Majestic Appliances 3096
5
m
Vermont Castings Jefferson Vent Free Gas Heater
General Information
Vent Free Features
The JUVS Gas Heater is an unvented gas appliance
tested and listed to the ANSI standard Z21.11.2.2000.
The Vent Free Gas Heater is configured to use Natural
Gas, (JUVSRN, JUVSMN ) or Propane (JUVSRP,
JUVSMP). Because these heaters are clean-burning
and highly energy-efficient, no venting system is
required.
tested and listed to the ANSI standard Z21.11.2.2000.
The Vent Free Gas Heater is configured to use Natural
Gas, (JUVSRN, JUVSMN ) or Propane (JUVSRP,
JUVSMP). Because these heaters are clean-burning
and highly energy-efficient, no venting system is
required.
The JUVS is shipped fully assembled with the
exception of the log set. The log set is assembled
during installation.
during installation.
The JUVS is equipped with a Honeywell control valve
that allows thermostatic control, on/off switch or a
remote switch (not supplied).
remote switch (not supplied).
The JUVS model incorporates variable regulators that
allow you to adjust burner heat output between HIGH,
(28,000 BTU), and LOW, (20,000 BTU). See the
Operation Section for details.
(28,000 BTU), and LOW, (20,000 BTU). See the
Operation Section for details.
The standing pilot incorporates an Oxygen Depletion
System (ODS/pilot) which shuts off gas flow to the
burner in the event that sufficient fresh air becomes
unavailable for continued safe operation.
burner in the event that sufficient fresh air becomes
unavailable for continued safe operation.
Unpack the Stove
Remove the stove assembly from the shipping carton
and inspect it for loose or damaged parts. Do not install
this appliance if any parts are loose or if there is any
visual or suspected damage resulting from shipping or
handling. Report damage to your dealer/distributor
immediately. The log set is packaged in the box
shipped inside the firebox.
To remove the packaged log set from the firebox:
and inspect it for loose or damaged parts. Do not install
this appliance if any parts are loose or if there is any
visual or suspected damage resulting from shipping or
handling. Report damage to your dealer/distributor
immediately. The log set is packaged in the box
shipped inside the firebox.
To remove the packaged log set from the firebox:
•
Lift the stove front up and then swing the bottom out
and away to disengage it from the stove body. (Fig. 3)
Cut the wire tie securing the screen.
Cut the wire tie securing the screen.
•
Remove the screen frame. (Fig. 4)
•
Remove box and set aside.
Contact your dealer if the burner is loose or damaged in
any way.
any way.
ST229b
Fig. 3 Remove stove front.
PILOT ADJ
Fig. 2 JUVS gas heater. Valve may be different.
Safety
Screen
Screen
Supply
Line Inlet
Line Inlet
OFF/ON/Pilot
Control Knob
Control Knob
Variable
Regulator
Regulator
Gas Valve
Piezo Ignitor
ST100
Rear Log
Bracket
Bracket
Pilot Hood &
Pilot
Pilot
Rheostat
Bracket
Bracket
ST208b
Fig. 4 Lift screen from firebox.
Screen Hooks