Справочник Пользователя для MASTER LOCK B350EAI

8

099565

1. Follow all ventilation and safety information.

2. Fill fuel tank with kerosene or No. 1 fuel oil.

3. Attach fuel cap.

4. Set thermostat dial to desired temperature. 

Note: 

Thermostat setting must be

higher than surrounding air temperature.

5. Plug power cord of heater into a standard 220/240 volt, 50 hertz, grounded

(earthed) outlet. Use an extension cord if needed. Use only a three-wire,
grounded (earthed) extension cord.

Up to 100 feet (30.5 meters) long, use 16 AWG (1.0 mm

2

) conductor

101 to 200 feet (30.6 to 61 meters) long, use 14 AWG (1.5 mm

2

) conductor

201 to 300 feet (61.1 to 91.5 meters) long, use 12 AWG (2 mm

2

) conductor

6. The motor will start when power cord is plugged into outlet. The heater should

ignite at once. If heater does not ignite, restart heater. To restart heater, wait 60
seconds, then push in safety control reset button. Safety control reset button is
at rear of heater near power cord (see Figure 4).

Note:

 If starting heater for first time, you may need to restart heater several times

before heater ignites. You may also have to do this after taking heater out of
storage.

Safety Control
Reset Button

WARNING ICON

G 001