Справочник Пользователя для Pelco C2400M-B

 

4

C2400M-B  (1/06)

 

The following items are supplied:

1

Heater and defroster attached to the front heater bracket

1

Heater attached to the rear heater bracket (HD3515 Series and HD3515L Series only)

1

PC board

Hardware to attach the heater bracket(s):

EH3508/EH3512 Series

EH3515/EH3515L Series

4

3/8-inch screws

4

3/8-inch screws

4

#6 nylon washers

4

#6 nylon washers

2

1/4-inch Phillips pan head screws

2

#6 lock washers

Hardware to attach the PC board (EH3508/EH3512/EH3515 only):
2 

6-32 x 3/8-inch Phillips pan head screws

4

#6 nylon washers

2

#6 lock washer

1

PC board cover

Perform the following steps to install the heater and defroster kit.

1. Disconnect all sources of power from the enclosure.

2. Unlatch and open the lid.

3. Remove the camera and camera sled.

a.

Disconnect the power and video from the camera.

b.

Loosen the screws that hold the camera sled in place.

c.

Slide the sled forward so it can be lifted out over the screws. 

 

d.

Retighten the screws so the sliding bar under the sled lip will not move. This will assure 
that you reinstall the camera and sled in the same place.

e.

Remove the camera and sled.

4. If there is a heater pad installed in the bottom of the enclosure or a defroster pad installed 

around the viewing window, disconnect and remove these pads.

5. Remove the bottom window bracket, and then remove the top window bracket.

 

  Do not try to reinstall the top and bottom window brackets.

6. Attach the heater bracket (with heater and defroster attached) to the inside face of the 

window using the screws provided (refer to Figure 1).