Справочник Пользователя для Aquacal 100

47

A. With the [dEL] (4 minute time delay) code message displayed use the [UP] or [DOWN]

arrow key to select either “1” to allow the time delay to remain active or “0” to deactivate the
time delay. Not pressing depressing any buttons for 15 seconds will allow the controller to
save the selection and return to the normal operating mode. Pressing the {POOL/SPA] key
will also save the selection and step to the next menu parameter [JAO] (External Controller
Interface).

B. CAUTION!!!: The time delay should only be deactivated for service convenience and must

be reactivated prior to placing the heat pump back is service. Failure to reset the time delay
feature could result in permanent damage to the heat pump compressor.

If it is believed the displayed pool or spa water temperature does not match the actual
temperature, follow the steps below to verify and adjust the controller as necessary. Be certain
to use an accurate thermometer:

A. With the circulating pump in operation, and water moving through the heater, use a reliable

thermometer to measure the temperature of the pool or spa water. Be sure to measure the
water temperature away from returns. The object is to accurately determine the temperature
of the water entering the heater.

B. Once you have measure the water temperature, compare the result to the heater’s

displayed water temperature. If the water temperatures are the same or within 1

o

F, no

calibration is necessary. If the temperatures differ by 2 to 3

o

F, calibration is necessary…

Perform calibration procedure as follows:

A. Configuring for External Controllers Using [JAO] Selection :

1) Follow the steps 1a. through 1d. above to enter the service menu. Once [dEL] is

displayed, press the [POOL/SPA] key until the display shows [JAO].

2) With the [JAO] (External Controller Interface) code message displayed, use the [UP] or

[DOWN] arrow keys to select either “0” to disable the External Controller Interface, “2” to
connect a thermostat type controller (2-wire connection), or “3,” to connect a thermostat
selector type controller (3-wire connection).

B. Configuring Remote Flow Switch / Automatic Thermostat Switching Using [FS2] Selection:

1) Follow the steps 1a. through 1d. above to enter the service menu. Once [dEL] is

displayed, press the [POOL/SPA] key until the display shows [FS2].

2) With the [FS2] (Remote Flow Switch / Automatic Thermostat Switching) code message

displayed, use the [UP] or [DOWN] arrows to select either “0” to disable Remote Flow
Switch / Automatic Thermostat Switching, “1” to enable Remote Flow Switch / Automatic
Thermostat Switching.

N

OTE

: A

LL

 

FLOW

 

SWITCH

 

KITS

 

PRODUCED

 

BY

 A

QUA

C

AL

 

ARE

 

SHIPPED

 

WITH

 

FULL

 

INSTALLATION

 

AND

PROGRAMMING

 

INSTRUCTIONS

. P

LEASE

 

CONTACT

 A

QUA

C

AL

 C

USTOMER

 S

UPPORT

 (800-786-

7751) 

IF

 

ADDITIONAL

 

COPIES

 

OF

 

THESE

 

INSTRUCTIONS

 

ARE

 

NEEDED

.