Справочник Пользователя для Mitsubishi Electronics MSZ-GA22VA

24

(1)  Slide the sleeve and check if there is a locking lever or not.

(2) The terminal with this connector has the 
      locking mechanism.

1

Slide the sleeve.

2

Pull the terminal while 

   pushing the locking
   lever.

1

Hold the sleeve, and 

   pull out the terminal 
   slowly.

The terminal which has the locking mechanism can be detached as shown below.
There are two types ( Refer to (1) and (2)) of the terminal with locking mechanism.
The terminal without locking mechanism can be detached  by pulling it out.
Check the shape of the terminal before detaching.

<"Terminal with locking mechanism" Detaching points>

(1) Remove the horizontal vane. 
(2) Remove the screw caps of the panel.

Remove the screws. (See Photo 1.)

(3) Hold the lower part of both ends on the panel and pull it 

slightly toward you, and then remove the panel by pushing 
it upward.

Screws of the panel

Horizontal vane

OB378_--1qxp  05.1.17 12:55  Page 24