Справочник Пользователя для Mitsubishi Electronics MSZ-GE18NA

28

Turn OFF power supply before disassembling.

(1) Remove the horizontal vanes.
(2) Remove the screw caps of the panel. Remove the 

screws of the panel.

(3) Unhook the lower part ( ) of the panel. 
(4) Hold the lower part of both ends of the panel and pull 

it 

slightly toward you, and then remove the panel by 

pushing it upward.

(1)  Slide the sleeve and check if there is a locking lever or not.

(2)  The terminal with this connector has the 
      locking mechanism.

Slide the sleeve.
Pull the terminal while 
pushing the locking
lever.

Hold the sleeve, and 
pull out the terminal 
slowly.

<"Terminal with locking mechanism" Detaching points>

The terminal which has the locking mechanism can be detached as shown below.
There are two types (refer to (1) and (2)) of the terminal with locking mechanism.
The terminal without locking mechanism can be detached by pulling it out.
Check the shape of the terminal before detaching.

Screws of the panel

Front panel

Horizontal vanes

A