Справочник Пользователя для Mitsubishi Electronics MSH-A18ND

18

(1)  Slide the sleeve and check if there is a locking lever or not.

(2) The terminal with this connector has the 
      locking mechanism.

1

Slide the sleeve.

2

Pull the terminal while 

   pushing the locking
   lever.

1

Hold the sleeve, and 

   pull out the terminal 
   slowly.

The terminal which has the locking mechanism can be detached as shown below.
There are two types ( Refer to (1) and (2)) of the terminal with locking mechanism.
The terminal without locking mechanism can be detached  by pulling it out.
Check the shape of the terminal before detaching.

<"Terminal with locking mechanism" Detaching points>

(1) Remove the screw caps of the front panel.

Remove the screws.

(2) Pull the panel down to your side slightly and unhook the

catches at the top.

Front panel

Screws

(1) Remove the front panel. (Refer to 1.)
(2) Remove the screw of the electrical cover.

Remove the electrical cover.

(3) Remove the screws of the V.A. clamp.

Remove the V.A. clamp.

(4) Remove the screw of the terminal block.
(5) Remove the screws of the ground wire.
(6) Disconnect all the connectors and all the lead wires on the

electronic control P.C. board.

(7) Remove the R.L holder.
(8) Remove the electronic control P.C. board.
(9) Open the R.L holder, remove the receiver P.C. board and

the display P.C. board.

Indoor
electronic
control
P.C.board

Vane motor 
connector 

Fan motor
connectors 

Screws of the ground wire

Screw of 
the electrical
cover

Screw of the
V.A. clamp

R.L
holder

Screw of
the terminal
block

Receiver
P.C.
board

OB427B-1.qxp  07.5.16 3:30 PM  Page 18