Справочник Пользователя для Mitsubishi Electronics PKA-A36KA.TH

29

(1) Press and unlock the knobs on both sides of the front 
   grille and lift the front grille until it is level. Pull the hinges 
   forward to remove the front grille. (See Photo 1)

(2) Remove 3 screw caps of the panel. Remove 5 screws. 
 

(See Photo 1)

(3) Unfix 3 hooks. (See Figure 1)
(4) Hold the lower part of both ends of the panel and pull it 

slightly toward you, and then remove the panel by pushing 
it upward.

(5) Remove the screw of the corner box. (See Photo 1)
   Remove the corner box.

Be careful when removing heavy parts.

(1) Remove the panel and the corner box. (Refer to 1.)
(2) Remove the front and side electrical box covers (each 1 

screw). (See Photo 2)

(3) Disconnect the connectors on the indoor controller board. 

(See Photo 3)

(4) Remove the switch board holder and open the cover.
(5) Pull out the indoor controller board toward you then remove 
 

the indoor controller board and switch board. (See Photo 3)

(6) Remove the holder of wireless remote controller board.
(7)

 

Disconnect the connector of wireless remote controller 

board and remove the wireless remote controller board 
from the holder.

Screws and screw caps

Screw of the 

corner box

Front grille

Hooks

Screw of electrical 
box cover (side)

Screw of electrical 
box cover (Front)

Switch board 
holder

Holder of wireless 
remote controller board

Indoor controller
board (I.B.)

Terminal block (TB4)

Electrical
box

Screws

Water Cut

Terminal block 
(TB2) (option)

Terminal block 
(TB5) (only PKA-KA)

Connector
for ground 
wire