Справочник Пользователя для Hitachi RAS-SX10HAK / RAC-SX10HAK

 

The internal cleaning operation is automatically performed after cooling, dehumidifying or dry cool operation to 
control mold growth by configuring the 

 (INTERNAL CLEAN) operation. (There is no mold removing function 

and disinfecting/sterilizing effect.)

Press the 

 (FUNCTION SELECTOR) button 

until 

 (INTERNAL CLEAN) blinks.

While 

 (INTERNAL CLEAN) is blinking, point the remote controller 

towards the unit and press the 

 (ON/OFF) button.

•  A short beep sounds and 

 (INTERNAL CLEAN) indicator turns on 

at the remote controller.

Press the 

 (FUNCTION SELECTOR) button again until 

(INTERNAL CLEAN) blinks.

While 

 (INTERNAL CLEAN) is blinking, point the remote controller 

towards the unit and press the 

 (ON/OFF) button.

•  A short beep sounds and 

 (INTERNAL CLEAN) indicator turns off 

on the remote controller.

• Internal cleaning operation is not performed if the duration of cooling, dehumidifying or dry cool operation is 

too short (below approximately 10 minutes).

• If the internal cleaning mode is set, the internal cleaning operation will automatically start when cooling, 

dehumidifying or dry cool operation is stopped. During internal cleaning, the heating operation and fan operation 
(with stainless plasma air purifying) are performed to control the mold growth inside the indoor unit.

• While   (ON TIMER) is set, internal cleaning operation is not performed from 2 hours before the preset 

time.

• Internal cleaning operation is not performed if the air conditioner operation is stopped in any of the following 

conditions below.

  (heating operation, stainless plasma air purifying operation, quick laundry operation and   (OFF TIMER) stop 

under condensation control operation, operation stopped by 

 (SLEEP) button.)

– 21 –

C

M

Y

CM

MY

CY

CMY

K

EN_21.ai   2010-7-8   10:22:24

EN_21.ai   2010-7-8   10:22:24