Справочник Пользователя для Hitachi RAS-SX10HAK / RAC-SX10HAK

Configuring the fan speed appropriate for sleeping and stop the operation at specified time.  

„  The display below indicates sleep timer which is set for 2 hours at 11:38 p.m. and the turn off time will be 

Press the 

 (SLEEP) button.

•  Every time you press the     (SLEEP) button, the mode will change   

as shown below.

Cancel the sleep timer

•  Preset time of sleep timer and the time at which the operation stops 

will be displayed on the remote controller. 

•  Fan speed remain “SILENT” during sleep timer operation.

Press the 

 (SLEEP) button or 

 (CANCEL) button.

•  Set the operation to auto stop by sleep timer operation, it can be set to start the operation next morning by 

 (ON TIMER). Set   (ON TIMER) first and then press the 

 (SLEEP) button.

„ The display below indicates   (ON TIMER) which is set at 6:00 a.m. and 2 hours sleep time at 

Preset the   (ON TIMER).
(Page 26, 27)

Press the 

 (SLEEP) button.

•  The unit will turn off in 2 hours (at 1:38 a.m.)  

and will turn on in order to reach the preset  
temperature by 6:00 a.m.

•  The time range of sleep timer operation should 

 be set before   (ON TIMER) time.

• When the sleep timer has been programmed, the unit 

will not operate even if the set time is reached unless 
the unit receives a signal from the remote controller. 
Confirm that Sleep Timer programming is complete 
(beep) and the   (TIMER) indicator of the indoor unit 
turns on.

– 29 –

C

M

Y

CM

MY

CY

CMY

K

EN_29.ai   2010-7-7   15:23:14

EN_29.ai   2010-7-7   15:23:14