Справочник Пользователя для Samsung AW10ECB

 appendix

 

appendix

TROUBLESHOOTING

Refer to the following chart if the air conditioner operates abnormally. This may save time and unnecessary 
expense of a service call. 

The air conditioner 

does not start operating 

immediately after it has 

been turned on.

•  Because of the protective mechanism, the appliance does not start 

operating immediately to keep the unit from overloading.  

The air conditioner will start in 3 minutes.

The air conditioner does 

not work at all.

•  Check that the power plug is properly connected. Insert the power plug 

into the wall socket correctly.

•  Check if the circuit breaker is switched off.
•  Check if there is a power failure.
•  Check your fuse. Make sure it is not blown out.

The temperature does 

not change.

•  Check if your air conditioner to make sure it is not operating in Fan mode. 

The cool(warm) air does 

not come out of the air 

conditioner.

•  Check if the set temperature is higher (lower) than the current 

temperature. Press the 

Temp button on the remote control or Temp. 

button on the control panel to change the set temperature.  

Press  or  to increase or decrease the temperature.

•  Check if the air filter is blocked by dirt. Clean the air filter every two weeks.
•  Check if the air conditioner has just been turned on. If so wait 3 minutes.

Odors permeate the 

room during operation.

•  Check if the appliance is running in a smoky area or if there is a smell 

entering from outside. Operate the air conditioner in Fan mode or open 

the windows to air out the room.

•  Check your ventilation lever and make sure it is in   position. Outside 

odors might come in when your ventilation lever is in   position.

The air conditioner 

makes a bubbling sound. 

•  A bubbling sound may be heard when the refrigerant is circulating through 

the compressor. This is normal operation. 

The air conditioner 

vibrates excessively 

or makes a lot of noise 

during operation.

•  Check if there is a gap between the air conditioner and the wall. Insulate 

the crack securely.

Water is dripping from 

the air flow blades.

•  Check if the air conditioner has been cooling for an extended period of 

time with the air flow blades pointed downwards. Condensation may 

generate due to the difference in temperature. Push the vertical air flow 

blades upward and run the appliance. 

Remote control is not 

working.

•  Check if your batteries are depleted.
•  Make sure batteries are correctly installed.
•  Make sure nothing is blocking the remote control sensor.

OPERATION RANGES

The table below indicates the temperature and humidity ranges the air conditioner can be operated within. 
Refer to the table for efficient use.

COOLING

Approximately 70˚F~90˚F Approximately 70˚F~110˚F

80% or less