Справочник Пользователя для Sanyo CL2432

This air conditioning system meets strict safety and operat-
ing standards. As the installer or service person, it is an
important part of your job to install or service the system so
it operates safely and efficiently. 

●

Carefully read this instruction booklet before beginning.

●

Follow each installation or repair step exactly as
shown.

●

Observe all local, state, and national electrical codes.

●

Pay close attention to all warning and caution notices
given in this manual.

This symbol refers to a hazard or
unsafe practice which can result
in severe personal injury or
death.

This symbol refers to a hazard
or unsafe practice which can
result in personal injury or prod-
uct or property damage.

These instructions are all you need for most installation
sites and maintenance conditions. If you require help for a
special problem, contact our sales/service outlet or your
certified dealer for additional instructions. 

The manufacturer shall in no way be responsible for
improper installation or maintenance service, including
failure to follow the instructions in this document. 

•

Do not supply power to the unit until all

wiring and tubing are completed or reconnected and
checked.

• Highly dangerous electrical voltages are used in this

system. Carefully refer to the wiring diagram and these
instructions when wiring. Improper connections and
inadequate grounding can cause accidental injury or
death.

• Ground the unit following local electrical codes.
• Connect all wiring tightly. Loose wiring may cause over-

heating at connection points and a possible fire hazard.

Be careful when picking up and moving the indoor and out-
door units. Get a partner to help, and bend your knees when
lifting to reduce strain on your back. Sharp edges or thin alu-
minum fins on the air conditioner can cut your fingers. 

Make sure the ceiling/wall/floor is strong enough to hold
the unit’s weight. It may be necessary to construct a
strong wood or metal frame to provide added support.

Properly insulate any tubing run inside a room to prevent
“sweating” that can cause dripping and water damage to
walls and floors.

Use a raised concrete pad or concrete blocks to provide a
solid, level foundation for the outdoor unit. This prevents
water damage and abnormal vibration.

Securely anchor the outdoor unit down with bolts and a
metal frame. Provide a suitable air baffle. 

Install the outdoor unit on a raised platform that is higher
than drifting snow. Provide snow vents.

• Use the flare method for connecting tubing.

• Apply refrigerant lubricant to the matching surfaces of

the flare and union tubes before connecting them, then
tighten the nut with a torque wrench for a leak-free con-
nection.

• Check carefully for leaks before starting the test run.

• Turn the power OFF at the main power box (mains)

before opening the unit to check or repair electrical
parts and wiring.

• Keep your fingers and clothing away from any moving

parts.

• Clean up the site after you finish, remembering to check

that no metal scraps or bits of wiring have been left
inside the unit being serviced.

• Ventilate any enclosed areas when installing or testing

the refrigeration system. Escaped refrigerant gas, on
contact with fire or heat, can produce dangerously toxic
gas. 

• Confirm upon completing installation that no refrigerant

gas is leaking. If escaped gas comes in contact with a
stove, gas water heater, electric room heater or other
heat source, it can produce dangerously toxic gas.

01-386 AirCon  12/11/01 4:48 PM  Page 1