Справочник Пользователя для Friedrich XQ10

Скачать
Страница из 36
7
920-197-00
Sash window installations
STEP 1  After removing the unit from shipping carton, remove tape holding 
decorative front in place. Lay front in a safe out-of-the-way place, then 
slide chassis out of cabinet (see Figure A).
STEP 2  Attach curtain assemblies to cabinet as shown in Figure B. Use eight 
(8) No. 8 x ⅜" slotted hex head screws (item #1, page 6).
STEP 3  Center cabinet in window with sill channel positioned against 
window stool as shown in Figure C, Section A-A.
STEP 4  Pull window sash down behind Shell Support Channel on top of 
cabinet; this helps hold cabinet in place. Install No. 8 x ⅞" hex 
head screw (item #3, page 6) in sill channel at bottom of window 
opening as shown in Figure C.
STEP 5  Extend the sliding curtains on each side so the frames fi t into 
the window channels. While holding the curtain frames in place, 
mark four (4) hole locations (hole locations are in the upper 
corners on  left and right curtain assembly), two (2) in the 
window jamb and two (2) in the window sash. Slip the curtains 
back from marked locations and drill four (4) 
7
/
64
" diameter pilot 
holes. Again, extend the sliding curtains on each side and then 
install two (2) no. 8 x ½" Phillips head screws (item #2, page 6) 
and two (2) No. 8 x 1 ¼" Phillips head screws (item #4) through 
the curtain frames as shown in Figure C.
Figure A
BASEPAN HANDLE
PULL STRAP
TO PULL UNIT FROM SLEEVE, USE PULL STRAP AND BASEPAN 
HANDLE LOCATED ON FRONT. OBTAIN ASSISTANCE OR HELP 
AS NECESSARY TO HOLD SLEEVE WHILE PULLING UNIT FROM 
SLEEVE. MAKE SURE AIR CONDITIONER IS ON FIRM SUPPORT 
BEFORE REMOVING UNIT FROM SLEEVE.
WHEN CARRYING OR HANDLING UNIT, OBTAIN ASSISTANCE OR 
HELP AS NECESSARY TO SUPPORT UNIT FROM BOTTOM (BASE 
PAN), MAINTAINING CLEARANCE FROM ALL OBSTACLES.
CURTAIN 
ASSEMBLY
RETAINING 
BRACKET
CURTAIN 
ASSEMBLY 
(LEFT)
SHELL SUPPORT 
CHANNEL
Figure B
SCREW #8 x 
⅜" SLOTTED HEX HEAD 
(ILLUSTRATION ON PAGE 6, ITEM #1) 
8 REQUIRED (4 EACH SIDE). INSTALL 
FROM INSIDE SLEEVE TO CURTAIN 
ASSEMBLY RETAINING BRACKET
CURTAIN 
ASSEMBLY 
(RIGHT)
  Figure  C
SECTION  A-A
SCREW, 1/2” PHILLIPS HEAD
(See illustration, item #2, page 6)
SCREW, 1 1/4” PHILLIPS HEAD
(See illustration, item #4, page 6)
SCREW, #8 x 7/8” HEX HEAD 
(See illustration, item #3, 
 page 6)
WINDOW STOOL
SILL 
CHANNEL
SHELL SUPPORT CHANNEL
WINDOW SASH
CABINET