Справочник Пользователя для Toshiba RAV-SM1403DT-A

– 141 –

Heat exchanger

Partition plate

Fin guard

Motor base

Motor base

Reactor assembly

Valve fixing plate

Top plate

Top plate

Front panel

Front panel

Side cabinet

Side cabinet

Motor base

Air outlet 

Air outlet 
cabinet

cabinet

Air outlet 
cabinet

Top plate

Front panel

Side cabinet

1

Common
procedure

Be sure to put on the gloves at any process; otherwise an
injury will be caused by the parts, etc.

1) Stop operation of the air conditioner and then turn off

switch of the breaker.

2) Remove the front panel.

(Hexagonal screws Ø4 × 10, 2 pcs.)
• Remove the screws and then remove the front panel

by pulling it downward.

3) Remove the power supply cable and the indoor/outdoor

connecting wire from the cord clamp and the terminal.

4) Remove the top plate.

(Hexagonal screws Ø4 × 10, 5 pcs.)

1) Attach the top plate.

(Hexagonal screws Ø4 × 10, 5 pcs.)

2) Connect the power supply cable and the indoor/outdoor

connecting wire to the terminal and then fix them with
the cord clamp.

For the power supply cable and the indoor/outdoor
connecting wire, be sure fix them using the bundling band
(procured locally) along the crossover pipe so that they do
not come to contact with the compressor, valve at gas side,
pipe at gas side and discharge pipe.

3) Attach the front panel.

(Hexagonal screws Ø4 × 10, 2 pcs.)

1) Carry out work of 1 of 

1

.

2) Remove screws for the air outlet cabinet and the

partition board. (ST1T Ø4 × 8, 4 pcs.)

3) Remove screws for the air outlet cabinet and the bottom

plate. (Hexagonal screws Ø4 × 10, 2 pcs.)

4) Remove screws for the air outlet cabinet and the motor

base. (ST1T Ø4 × 8, 2 pcs.)

5) Remove screw for the air outlet cabinet and the heat

exchanger. (ST1T Ø4 × 8, 1 pc.)

6) Remove screws for the air outlet cabinet and the fin

guard. (Hexagonal screws Ø4 × 10, 2 pcs.)

7) Remove screws for the air outlet cabinet and the reactor

assembly.  (ST1T Ø4 × 8, 2 pcs.)

1) Carry out work of 1 of 

1

.

2) Remove the screws which fix the inverter assembly and

the side cabinet.  (ST1T Ø4 × 8, 2 pcs.)

3) Remove the screws which fix the side cabinet and the

valve fixing plate.  (ST1T Ø4 × 8, 2 pcs.)

4) Remove screws which fix the side cabinet and the piping

panel (Rear).  (Hexagonal screws Ø4 × 10, 2 pcs.)

5) Remove screw for the side cabinet and the bottom plate.

(Hexagonal screws Ø4 × 10, 1 pc.)

6) Remove screws for the side cabinet and the fin guard

(Heat exchanger).  (Hexagonal screws Ø4 × 10, 5 pcs.)

Air outlet
cabinet

Side cabinet

2

3