Справочник Пользователя для Toshiba RAM-SM800AT-E

54

The operation lamp goes on, and the operation starts.

One push of the button, in each time the display
changes in the order shown on the right.

• In HEAT 

 mode, if the room temperature reaches to the set temperature, the outdoor unit stops and

the air flow becomes LOW and the air volume decreases.

• In the defrost mode, the fan stops so that cool air is not discharged and PRE-DEF 

 is displayed.

One push of the button, in each time the display
changes in the order shown on the right.

• When air volume is “AUTO 

”, air volume differs according to the room temperature.

• In DRY   mode, “AUTO 

” is displayed and the air volume is LOW.

• In heating operation, if the room temperature is not heated sufficiently with fan mode “LOW 

” opera-

tion, select “MED. 

” or “HIGH 

” operation.

When you use the air conditioner for the first time or when you change SET DATA value, follow the procedure

below. From the next time, the operation will start as set state by pushing the 

 button.

• When the power supply is turned on, display section is displayed on the remote controller.

*

After the power supply is turned on, the remote controller does not accept an operation for approx. 1 minute,
but it is not a failure.

• While using the air conditioner, operate it only with 

 button without turning off the main

power switch and the leakage breaker.

• When starting the operation after stop for a long time, turn on the main power switch for 12 hours or

more before start. (This is required to turn on the compressor case heater for warming in order to
prevent overload on the compressor when activating the outdoor unit.)

AUTO

HEAT

DRY

COOL

FAN

        LOW

         MED.

         HIGH

     AUTO

UNIT

SET

CL