Справочник Пользователя для Bard w17a2

Manual 2100-581B 

Page  18 of 26

This unit was charged at the factory with the quantity of 
refrigerant listed on the serial plate.  AHRI capacity and 

efficiency ratings were determined by testing with this 
refrigerant charge quantity.

The following pressure tables show nominal pressures 

for the units.  Since many installation specific situations 
can affect the pressure readings, this information should 

only be used by certified technicians as a guide for 
evaluating proper system performance.  They shall not 
be used to adjust charge.  If charge is in doubt, reclaim, 
evacuate and recharge the unit to the serial plate charge.

  1. Disconnect all power to the unit.

  2. Remove the screws holding both grilles, one on 

each side of unit, and remove grilles.

  3. Remove screws holding fan shroud to condenser 

and bottom.  Nine (9) screws.

  4. Unwire condenser fan motor.

  5. Slide complete motor, fan blade, and shroud 

assembly out the left side of the unit.

  6. Service motor/fan as needed.

  7. Reverse steps to reinstall.

"A"

AIRFLOW

MIS-1724

W17A2 / W17L2

W18A2 / W18L2

W24A2 / W24L2

1.00"

W30A2 / W30L2

W36A2 / W36L2

1.25"

W42A2 / W42L2

W48A2 / W48L2

W60A2 / W60L2

W70A2 / W70L2

1.75"

Shown in Figure 8 is the correct fan blade setting for 
proper air delivery across the outdoor coil.  Refer to 

Table 1 for unit specific dimension.

Any service work requiring removal or adjustment 
in the fan and/or motor area will require that the 
dimensions below be checked and blade adjusted in or 
out on the motor shaft accordingly.