Справочник Пользователя для Quadra-Fire QUADRA-FIRE CONTOUR

October 10, 2001                                                                    24                       

 

                                  250-5583

Contour Pellet Stove

1.  Unplug stove.

2.  Remove both side curtains by opening halfway, then 

lifting up and pulling back.

3.  Disconnect vacuum hose and both wires (orange and 

red) from the vacuum switch so you can remove the top 

rear screen.

4.  Unscrew and remove top rear screen.

5.  Unscrew lower rear screen, and lay it on it's back as 

shown in Fig. 1.

Included in Kit:  (1) Blower; (1) Gasket 

Tools Required:  Phillips Screwdriver; Flathead 

Screwdriver or 1/4" Nutdriver.

6.  Remove both wires from exhaust blower (blue and 

double white).

7.  Remove 6 screws using a flathead screwdriver or a 

1/4" nutdriver.  Retain screws for use on replacement 

blower. See Fig 2.

8.  Remove exhaust blower and gasket. 

9.  Install new gasket and blower by reversing steps 1-8.

1.  UNPLUG THE STOVE.

2.  Open the right Side Curtain to expose the Feed Motor.

3.  Disconnect  the  Molex  connectors.    Remove  the  two 

screws from the Feed Motor Mount.  (Figure 1)

4.  Pull the Feed Motor/Auger assembly straight out towards 

you, being careful not to hit the Control Box.

5.  Loosen set screw that secures Auger Shaft to Feed Motor 

Shaft. (See Figure 2),  Remove 4 screws attaching Feed 

Motor to mount. Lift off old motor and replace with new. 

Secure with screws. Ensure Auger Shaft set screw aligns 

with flat side of Feed Motor Shaft. 

6.   Re-assemble in reverse order. 

CONTOUR

 

SHOWN

 

WITH

 

TOP

 

REAR

 

SCREEN

 

AND

 

VACUUM

 

SWITCH

 

REMOVED

.

Molex Connectors

Feed Motor Mount Screws