Справочник Пользователя для Quadra-Fire 31M-ACC-MBK

Page  20

7033-277C

March 2, 2007

R

SparkArestor Cap

Roof Flashing

Storm Collar

Joist Shield/Firestop

Double wall
connector pipe

Floor Protector

Outside Air Floor Vent

OutsideAir
Rear Vent

Maintain structural integrity of mobile home:

•   Floor, wall, ceiling and/or roof.

Do NOT cut through:
•  Floor joist, wall, studs or ceiling trusses.
•  Any supporting material that would affect the structural 

integrity.

• 

Never install in a sleeping room.

Consumes oxygen in the room.

10.  Burn wood only.  Other types of fuels may generate 

poisonous gases (e.g., carbon monoxide).

11.  If unit burns poorly while an exhaust blower is on in 

home, (i.e., range hood), increase combustion air.

12.  Installation shall be in accordance with the Manufacturers 

Home & Safety Standard (HUD) CFR 3280, Part 24.

1.  An outside air inlet must be provided for combustion   See 

page 14 for installation information.

2.  Appliance must be secured to the mobile home structure 

by bolting the pedestal through hearth pad and into 
fl oor.  

3.  Appliance must be grounded with #8 solid copper 

grounding wire or equivalent and terminated at each end 
with N.E.C. approved grounding device.

4.  Appliance must be installed with an approved UL103 HT 

ventilated chimney connector, UL103 HT chimney, and 
terminal cap with spark arrestor.  Never use a single wall 
connector (stove pipe) in a mobile home installation.  Use 
only double-wall connector pipe, Dura-Vent DVL, Selkirk 
metalbestos DS or Security DL double-wall connector or 
any listed double-wall connector pipe.

5.  In Canada, this appliance must be connected to a 6 inch 

(152mm) factory-built chimney conforming to CAN/ULC-
629M, STANDARD FOR FACTORY BUILT CHIMNEYS. 

6.  Follow the chimney and chimney connector manufacturer’s 

instructions when installing the fl ue system for use in a 
mobile home.

7.  Maintain clearance to combustibles.

8. Floor protection requirements must be followed 

precisely.

9.  Use silicone to create an effective vapor barrier at the 

location where the chimney or other component penetrates 
to the exterior of the structure.

NOTE:  Offsets from the vertical, not exceeding 45°, are 
allowed per Section 905(a) of the Uniform Mechanical Code 
(UMC). Offsets greater than 45° are considered horizontal 
and are also allowed, providing the horizontal run does not 
exceed 75% of the vertical height of the vent. Construction, 
clearance and termination must be in compliance with the 
UMC Table 9C. This installation must also comply with NFPA 
211.

NOTE: Top sections of chimney must be removable to allow 
maximum clearance of 13.5 feet (411cm) from ground level 
for transportation purposes.