Справочник Пользователя для Procom SL250TYLA-D

1.

From back of heater remove the

knock-out center panel with two

brackets at the four sides with a Philips

head screwdriver (see Figure 1).

2.

Attach the two brackets to blower

housing using four white screws

provided in blower kit (2 for each

bracket) (see Figure 3). Tighten

screws securely. Then guide the green

grounding means wire and downlead

of motor through the rubber capped

hole.

3.

Guide the four strand wire of downlead
through the jacket hole. Connect the
two yellow leads and the temperature
control switch on the temperature
controlled bracket togther. Secure the
temperature controlled bracket on the
reflective panel of firebox using two self-
tapping screws(See Figure 4-A).

4.     Using the previously removed screws,

mount blower assembly to heater by
reattaching the knock-out center panel
to rear panel. Draw the four strand cable

10. Plug power cord into a convenient 3-

prong grounded wall receptacle near

the heater.

backward so as to expose the three
black, green, white lines on the four
strand cable at the back of rear panel.
Be sure not to drop the temperature
controlled wire off the reflective panel.
Connect the green grounding means
wire and four strand cable together.
Connect the two black motor downleads
respectively and the remaining two black
and white wires together by the same
means (see Figure 4-A). (Note: the
three wires must be connected at the
rear panel)

5.

Using the thread that previously bond

the electrical wire to collect and pack

the outside connection wire of the

cable.

6. 

    Place operation control housing at the

bottom of stove. Use two black screws
provided in blower kit. Mount blower
operation control housing to the bracket
at the bottom of stove (see Figure 5).

7.

Check to make sure that the power cord

is completely clear of blower wheel and

there are no foreign objects in blower

wheel.

8.     Use  screws provided in blower kit to

assemble  the  plate which assembled
with strain  relief  bushing  and  power

cord on the knockout  center panel.

9.

Peel off the backing paper and stick the

supplied wiring diagram decal on the

back panel as show in Figure 4-B.

Tools  required: Philips screwdriver

WARNING: 1. ELECTRICAL GROUND-

11. Using Auto/O/Man switch. Turn blower

on and check for operation. Turn on

Auto/O/Man switch to the desired

position. Man position will remain con-

stantly on. Auto position will be con-

trolled by the thermostat on fan blower

unit. To stop the operation, turn unit

switch to the O position.

12. All remaining parts from blower kit  may

be discarded.

P