Справочник Пользователя для Jacuzzi EV77959

c)  Adjust mounting plate so length (L) between the front of the toilet 

bowl and the back of the mounting plate is as follows:

d)  Tighten Mounting Bolts with screwdriver until the mounting plate is 

securely fastened to the toilet.  

NOTE: If your water supply line is rigid pipe, 
you may need to replace it before installing 
the Refresh Personal Hygiene System™.

a)  Install the T-Valve between the water supply line 

and the toilet tank.

b)  Place the Refresh on or beside the toilet and 

connect the Bidet Hose to the Refresh.

IMPORTANT: Use wrench to tighten all 
connections before continuing.  Failure to 
do so could result in flooding, leaking, or 
damage to the Refresh Personal Hygiene 
System™.  Do not overtighten!

a)  Slide the Refresh onto the mounting plate.  

You will hear a “click” indicating the seat has 
been properly attached. 

 

Confirm that the seat switch is in full        
contact with the toilet bowl rim.

To Release the Refresh: 
Unplug the power plug and turn the water 
supply valve OFF.  
Push the button located on the right corner 
of the seat and gently pull.  

CAUTION: Use only a grounded 

15 Amp GFCI outlet!

a)  Turn the water supply valve ON slowly.  

Ensure the connections are not leaking 
before continuing.

IMPORTANT! Make sure work area is dry 
and hands are dry before continuing.

b)  Insert power plug into a grounded 15 Amp 

GFCI outlet.  The blue power LED on the 
Refresh Display Panel will illuminate.

IMPORTANT! Make sure the power plug is 
removed and the water supply is shut-off 
before removing the Refresh.

a)  Remove battery cover from Remote Control 

and insert two (2) AAA batteries (included) 
as shown.

b)  Refasten battery cover with screw.

Press to 

Release

Water Supply Line

T-Valve

Bidet Hose

power

power save

seat heat

seat sensor

EX93000   Refresh Installation Manual  10/06