Справочник Пользователя для Dakota Digital LAT-NR170
7. Insert the new LED assembly through the hole where the original bulb and connector were.
Use caution when feeding the wires through to avoid damaging the wire insulation.
8. Feed the wires through the large hole in the back plate and attach the
back plate onto the back side of the housing. The flat side of the
mounting disk should be toward the outside and the side with the slight
raised center should go in toward the housing. This will align the mount
in the original housing.
mounting disk should be toward the outside and the side with the slight
raised center should go in toward the housing. This will align the mount
in the original housing.
9. Secure the back plate with the supplied #6 lock nuts.
10. Make sure the original lens gasket is in place and replace the tail light lens.
11. Replace the chrome trim and then tighten down carefully.
11. Replace the chrome trim and then tighten down carefully.