Справочник Пользователя для Panasonic SC-HTB485

RQT0A04

There is no audio.
The power of the main unit turns off 
automatically.
(When the main unit detects a problem, a safety 
measure is activated and the main unit 
automatically switches to standby mode.)
≥ There is a problem with the amplifier.
≥ Is the volume extremely high?

If so, lower the volume.

≥ Is this system placed in an extremely hot place?

If so, move this system to a cooler place and 
wait a few moments and then try to turn it on 
again.

If the problem persists, confirm the display, turn 
this system off, remove the AC mains lead cord 
and consult your dealer. Please be sure to 
remember the display that was indicated and 
inform the dealer.

“F61”
≥ There is a problem with the amplifier of the 

system.

≥ Disconnect the AC mains lead and consult the 

dealer.

“F70 HDMI” / “U701” / “U703”
≥ Check HDMI connection.
≥ Turn off the main unit and then switch it on 

again.

≥ Disconnect the HDMI cable.

“F76”
≥ There is a problem with the power supply.
≥ Disconnect the AC mains lead and consult the 

dealer.

“U704”
≥ This system is receiving unsupported video 

format signal from the input source.
jChange the video resolution setting on the 

connected device. (Refer to the operating 
instructions for the device.)

jIf there is no image, connect the device 

directly to the TV to change the settings.

No power.
Ensure the AC mains lead of the active subwoofer 
is connected properly.

After turning the subwoofer on, it immediately 
turns off.
Unplug the AC mains lead and consult your 
dealer.

No sound from the subwoofer.
≥ Check that the active subwoofer is turned on.
≥ Check that the WIRELESS LINK indicator lights 

green. (> 19)

The WIRELESS LINK indicator lights red.
≥ There is no link between the main unit and the 

active subwoofer.
jCheck that the main unit is turned on.
jTurn the active subwoofer off and then back 

on. Alternatively, turn the active subwoofer off, 
disconnect the AC mains lead and then 
reconnect it.

≥ The active subwoofer and the main unit may not 

be paired correctly. Try the following operation. 
(Wireless pairing)
1 Turn on the main unit and active subwoofer.
2 Press and hold [ID SET] on the rear of the 

active subwoofer for more than 3 sec. 
(The WIRELESS LINK indicator will blink in 
red.)

3 While pressing and holding [INPUT] on 

remote control, press and hold [VOL i] on 
the main unit for more than 4 sec. 
(“SUBWOOFER PAIRING” will be indicated 
on the display.)

≥ When the wireless pairing is successful, “PAIRED” 

will be indicated on the display for 2 sec and 
WIRELESS LINK indicator lights green.

4 Turn the main unit off and on.

≥ Consult your dealer if the problem persists.

SC-HTB485-EGEBGN_RQT0A04-B.book  28 ページ  ２０１５年１月２２日　木曜日　午前１０時１５分