Справочник Пользователя для Mitsubishi Electronics 838 SERIES

6. NetCommand Control of an A/V Receiver (838 Series)

For assistance call 1(800) 332-2119

Setting Up A/V Receiver Control

Power and Volume

Perform this setup to control A/V receiver power and
volume with the TV’s remote control.

To perform this setup you need:

• The remote controls for both the TV and the

A/V receiver.

• An IR emitter cable available from Mitsubishi.

Before You Begin

Connect your A/V receiver to the TV and any addi-
tional devices.

Connect the IR emitter cable to the TV and position
the IR emitter where it can send signals to the A/V
receiver. See “IR Emitters,” page 65.

Set the

TV’s remote control to TV mode.

Setup to Control A/V Receiver Power and Volume

Open the

Inputs > AVR menu.

The first function highlighted in the

AVR screen is

always

Power. Aim the TV’s remote control at the

TV and press

ENTER to begin learning for Power.

Inputs > AVR screen. Perform
NetCommand IR “learning” for A/V
receiver power and volume keys.

When the

Power text starts flashing, aim the A/V

receiver’s remote control at the TV and hold the
POWER or POWER ON key until a check mark appears
next to

Power.

• If the text stops flashing before the check mark

appears, repeat this step.

• To remove the key from NetCommand control,

press the

CANCEL key while the key name is

highlighted.

Press the key on the

TV’s remote control to highlight

other keys in the list. Repeat steps 2 and 3 for each addi-
tional function you wish to control through NetCommand.

If the A/V receiver has a separate

POWER OFF key,

press on the

TV’s remote to highlight Power Off.

Repeat steps 2 and 3 to “learn” the

POWER OFF key.

If the device has no POWER OFF key, skip this step.

When finished “learning” the power and volume
keys, press

EXIT to watch TV or continue

NetCommand setup if using an HDMI connection.