Справочник Пользователя для Tascam SN29401376

Скачать
Страница из 96
Turning On & Basic Operations
En-41
With the sleep timer, you can set the AV receiver to turn 
off automatically after a specified period.
You can adjust the brightness of the AV receiver’s display.
You can display various information about the current 
input source as follows.
The following information can be typically displayed.
*1
When AM or FM radio is used, the band, preset number, and 
frequency are displayed. 
*2
If the input signal is digital, the signal format is displayed. 
Information is displayed for about three seconds, then the 
previously displayed information reappears.
When you connect an 
u-capable component, you must 
configure the input display so that 
u can work properly.
This setting can be done only from the front panel.
Using the Sleep Timer
1
Press 
RECEIVER once followed by SLEEP 
repeatedly to select the required sleep time.
The sleep time can be set from 90 to 10 minutes in 10 
minute steps.
The SLEEP indicator lights on the AV receiver’s 
display when the sleep timer has been set. The 
specified sleep time appears for about 5 seconds, then 
the previous display reappears.
Tip
• If you need to cancel the sleep timer, press SLEEP 
repeatedly until the SLEEP indicator goes off.
• To check the time remaining until the AV receiver sleeps, 
press SLEEP. Note that if you press again on SLEEP as 
the time being displayed is 10 minutes or less, the sleep 
timer will go off.
Setting the Display Brightness
1
Press 
RECEIVER once followed by DIMMER 
repeatedly to switch between: normal, dim, or 
dimmer brightness.
Tip
• (North American models) Alternatively, you can use 
DIMMER on the AV receiver.
Displaying Source Information
1
Press 
RECEIVER once followed by DISPLAY 
repeatedly to cycle through the available 
information.
Tip
• Alternatively, you can use DISPLAY on the AV receiver.
Sampling
frequency
Input source &
volume
Signal format
Listening mode
Input signal
resolution
Output resolution
Changing the Input Display
1
Press 
TV/CD or GAME.
TV/CD” or “GAME” appears on the AV receiver’s 
display.
2
Press and hold down the same button (about 
3 seconds) to change the input display.
Repeat this step to select the desired input display.
Note
• “DOCK” can be selected for the “TV/CD” or “GAME” 
input selector, but not at the same time.
• Enter the appropriate remote control code before using the 
remote controller for the first time (
TV/CD  
→  
DOCK
 
 
TAPE
 
TV/CD:
GAME 
 DOCK
GAME: