Справочник Пользователя для Insignia 29400403A

Insignia NS-HTIB51A 5.1 Channel Home Theater System

www.insigniaproducts.com

The M.Opt indicator lights on the display.

You can adjust the brightness of the receiver’s 
display.

• Press RECEIVER, then press DIMMER 

repeatedly to select: Dim, Dimmer, or Normal 
brightness.

• Press RECEIVER, then press MUTING.

The output is muted and the MUTING indicator 
flashes on the display.

With the sleep timer, you can set the receiver to turn 
off automatically after a specified period.

• Press RECEIVER, then press SLEEP repeatedly 

to select the sleep time you want.

The sleep time can be set from 90 to 10 minutes, 
in 10 minute steps.

The SLEEP indicator lights on the display when 
the sleep timer has been set. The specified sleep 
time appears on the display for about five 
seconds, then the previous display reappears.

To use headphones:
• Connect a pair of stereo headphones with a 

standard plug (1/4 inch or 6.3 mm) to the 
PHONES jack.

Important: The procedures described in this 
section use the buttons on the front panel, unless 
otherwise specified.

With the built-in tuner you can enjoy AM and FM 
radio stations. You can store your favorite stations 
as presets for quick selection.

To listen to the radio:
• Press TUNER to select either AM or FM (each time 

you press TUNER, the radio band changes 
between AM and FM).

In this example, FM has been selected.

• To automatically tune to a station:

• Press TUNING MODE until the AUTO 

indicator appears on the display.

• Press TUNING 

 or 

. The receiver 

automatically searches for stations and 
stops when a station is found.

- OR - 

• To manually tune to a station:

• Press TUNING MODE until the AUTO 

indicator goes off.

• Press and hold TUNING  

or . 

The 

receiver tunes up or down the frequency 
band as long as you hold the button. Press 
the button repeatedly to tune up or down 
by steps.

- OR - 

• To tune to a station by entering the frequency:

•

The music optimizer function only works with 
PCM digital audio input signals with a sampling 
rate below 48 kHz and analog audio input 
signals. The music optimizer is disabled when 
the direct listening mode is selected.

•

The setting is stored individually for each input 
selector.

•

To unmute, press MUTING again or adjust the 
volume.

•

Muting is also cancelled when the receiver is set 
to Standby.

•

To cancel the sleep timer, press SLEEP 
repeatedly until the SLEEP indicator goes off.

•

To check the time remaining until the receiver 
turns off, press SLEEP. If you press SLEEP while 
the sleep time is being displayed, the sleep time 
is shortened by 10 minutes.

•

Always turn down the volume before 
connecting your headphones.

•

While the headphones plug is inserted in the 
PHONES jack, the speakers are turned off.

•

When you connect a pair of headphones, the 
listening mode is set to Stereo, unless it is 
already set to Stereo, Mono, or Direct.

•

The listening modes cannot be selected while a 
pair of headphones is connected.

You can also press the TUNE MODE and arrow 
buttons on the remote control.

•

In Manual Tuning mode, FM stations are in 
mono.

•

If the signal from a stereo FM station is weak, it 
may be impossible to get good reception. In this 
case, switch to Manual Tuning mode and listen 
to the station in mono.

•

You can also press the TUNE MODE and arrow 
buttons on the remote control.

Band

Frequency

AUTO

FM Stereo

TUNED

NS-HTIB51A_10-0114_MAN_.book  Page 15  Tuesday, April 13, 2010  10:19 AM