Справочник Пользователя для Barco MGP 15
Display controller installation
31
6. Connect the primary display to the connector marked “VID 1”
on the BarcoMed 2MP2CP display controller using the
provided DVI cable (see figure figure 9 on page 31). For a
dual-headed BarcoMed 2MP2CP setup, connect the
secondary display to the other connector on the display
controller.
provided DVI cable (see figure figure 9 on page 31). For a
dual-headed BarcoMed 2MP2CP setup, connect the
secondary display to the other connector on the display
controller.
7. Reconnect the power cord, turn on the power, and boot the
system as usual.
Running multiple BarcoMed 2MP2CP Display Controllers in a single host
The physical order of the displays may vary when you are
running multiple BarcoMed 2MP2CP display controllers. This is
due to the PC’s PCI bus control in the system BIOS, and not the
BarcoMed display controller. It may become necessary,
depending on how your PC’s BIOS configures the PCI bus, to
switch your DVI display connections to achieve a linear desktop
configuration.
running multiple BarcoMed 2MP2CP display controllers. This is
due to the PC’s PCI bus control in the system BIOS, and not the
BarcoMed display controller. It may become necessary,
depending on how your PC’s BIOS configures the PCI bus, to
switch your DVI display connections to achieve a linear desktop
configuration.
Figure 9