Справочник Пользователя для Shark EP750ST

1. Your  cordless vacuum operates when the batteries are fully charged.  

16-20 hours.

2. Place ‘On/Off’ switch to the ON position.

1.

Connect the charger jack to the charging hole on the underside of the 
charging stand. (See fig. 1)  Plug the the charging transformer into the wall 
outlet.

2.

This vacuum cleaner is powered by Ni-Cd batteries.  Before first use, 
they must be charged for a minimum of 16 hours.

3.

Once the batteries are fully charged, the vacuum cleaner will run for 
approximately 20 minutes before recharging is required.

4.

When recharging the unit, the ‘On/Off’ Switch must be in the OFF position.

5.

Place the vacuum in the charging stand. Charging times will vary depending 
upon the amount of usage between charging cycles.

6.

The charging light indicator (5) on the vacuum will illuminate to indicate that
the vacuum is properly charging.

The Cordless Vacuum is a very powerful unit.  Make
sure that you hold it firmly, otherwise it can slip out of 
your hand and cause injury.

NOTE: Peak performance may only be realized after the 

unit has been charged and discharged two (2) or 
three (3) times.

1. To open the Dust Cup (container) (1), press down on the release button 

(2) and pull out the Dust  Cup (container ) (1), (fig. 1).

2. Pull out the Dust Cup Filter (4), (fig. 2).

3. Empty the dust from the Dust Cup Filter (4), (fig. 3).

4. Rinse the Dust Cup Filter (4) in cold water, and then wait until it dries

completely before replacing it into the Dust Cup (container) (1).

5. Place the Dust Cup Filter (4) carefully into the Dust Cup (container) (1).

6. Attach the Dust Cup (container) (1) to the Cordless Vacuum.

IMPORTANT: To maintain peak performance of your 

cordless hand vacuum, it is recommended 
that the unit be fully discharged, then 
completely re-charged at least once a month.

Fig. 1

Fig. 1

Fig. 2

Fig. 3

It is recommended that the dust cup filter be changed every 

three (3) months to ensure peak performance of the unit.

The suction hole must be open, free of any obstructions

at all times. Otherwise, the motor will overheat and could
become damaged.