Справочник Пользователя для Shark MV2010WC
4
TOLL FREE:
1-800-798-7398
5
www.SharkVacThenSteam.com
English
3
Place your foot lightly on the top
of the cleaning unit base. Tilt the
cleaning unit back. Vacuum your
floors.
cleaning unit back. Vacuum your
floors.
IMPORTANT: Vacuum all surfaces
first before steam-cleaning to
avoid condensation build-up. Avoid
vacuuming after steam mopping.
first before steam-cleaning to
avoid condensation build-up. Avoid
vacuuming after steam mopping.
NOTE: If you vacuum and then
steam-clean one room, before
moving on to the next, wait 10
minutes for the condensation to
clear before vacuuming again.
steam-clean one room, before
moving on to the next, wait 10
minutes for the condensation to
clear before vacuuming again.
USING VACUUM MODE
1
Pull and twist the quick release cord
holder to unwrap the power cord
completely. Plug in the unit.
completely. Plug in the unit.
2
To vacuum, slide the toggle switch
until the vacuum power button is
exposed. Press the vacuum power
mode button to the
exposed. Press the vacuum power
mode button to the
ON “I” position.
IMPORTANT: You cannot use the
vacuum function if the frame and
pad are attached to the base of the
cleaning unit.
vacuum function if the frame and
pad are attached to the base of the
cleaning unit.
NOTE: Only vacuum sealed and
non-carpeted bare floor surfaces.
Refer to floor manufacturer
guidelines and warnings.
non-carpeted bare floor surfaces.
Refer to floor manufacturer
guidelines and warnings.
Getting Started: Vacuum and Steam Panel
Vacuum Mode
OPERATING IN VACUUM MODE:
1
Remove steam pad and frame,
if attached. See page 11 for
instructions. Vacuum will not activate
if steam frame is attached.
instructions. Vacuum will not activate
if steam frame is attached.
2
SLIDE THE TOGGLE SWITCH UP to
expose the vacuum power button.
expose the vacuum power button.
3
Press the
VACUUM POWER BUTTON
to the
ON “I” position to activate
the vacuum.
OPERATING IN STEAM MODE:
1
Attach steam pad and frame.
Steam mode will not work if the pad
and frame are NOT attached. See
page 8 for assembly instructions.
and frame are NOT attached. See
page 8 for assembly instructions.
2
Fill the water tank.
SLIDE THE TOGGLE SWITCH DOWN
to expose the Steam Power button.
to expose the Steam Power button.
3
Press the
STEAM POWER BUTTON
to the
ON “I” position. The button
will be illuminated red when steam
mode is activated.
mode is activated.
4
Wait 30 seconds to heat water, then
TILT HANDLE BACK TO ACTIVATE
STEAM PUMP.
TILT HANDLE BACK TO ACTIVATE
STEAM PUMP.
The
Vac-Then-Steam™ has two
operating modes:
After inserting the telescopic handle,
your cleaning system is vacuum-ready.
Begin vacuuming your hard-surface
floors by tilting the cleaning unit back
and pressing the vacuum power button.
your cleaning system is vacuum-ready.
Begin vacuuming your hard-surface
floors by tilting the cleaning unit back
and pressing the vacuum power button.
2
3
1
1
1
2
2
3
3
VACUUM MODE:
STEAM MODE:
DO NOT USE STEAM PAD AND
FRAME IN VACUUM MODE
MV2010WC_11_IB_ENG_100803.indd 4-5
04/08/10 9:38 AM