Справочник Пользователя для Shark EP600

Voltage:

120V.,  60Hz.

Power:

7.5 Amps, 900 Watts

• Hold the dust cup in your hand.

• Make sure that the slot on the bottom 

of the cup is pointed in the same 

direction as the pins in the unit (see

drawing #1).

• Slide the dust cup inside to the end of 

its place in the unit (see drawing #2).

• Turn the dust cup 90° in the direction 

shown in the drawing (#3) at right.

• The unit is now ready to be used 

again.

To keep the vacuum cleaner 

looking new, it can be wiped with a damp 
cloth and a mild soap solution, then 
thoroughly dried.  Never use any type of 
chemical cleaners as they can damage 
the vacuum cleaner.  When not in use, 
store the vacuum cleaner in a dry, clean 
place.

After extended use, the body 

of the vacuum cleaner may become hot.  
When using the unit with the shoulder 
strap, the unit will touch the body of the 
user. Therefore make sure to use the 
vacuum cleaner with the strap only  when 
the unit is cool. If it gets too warm, allow it 
to cool before continuing to use it.

IMPORTANT:

This unit is equipped 

with a motor protective thermostat.  If 

for some reason the vacuum cleaner 

should overheat, the thermostat will 

automatically turn the unit off.  Should 

this occur:

• Push the On/Off button once.

• Disconnect the plug from the 

power source.

• Check the source of overheating 

problem. (i.e. clogged hose or 

filter).

• If clogged hose or filter is found, 

unclog the hose and replace the 

filters.

• Wait at least 45 minutes before 

attempting to reuse the vacuum.

• After unit has cooled down for 

45 minutes, plug in the cleaner 

and push the On/Off button. The 

vacuum should start again.

• If the vacuum still does not start, 

contact customer service at 

1-800-798-7398.

Use the hooks to attach the shoulder 

strap to the vacuum cleaner.
Connect the dog leash swivel hooks 

to the eyelets located near the top of 

the unit handle and at the base of the 

unit. Adjust the strap as required for 

comfort.