Справочник Пользователя для Shark APL1172 N
Insert into
Lower Handle
Fig. 1a
Fig. 1b
Fig. 1
1. Assemble the extension tubes by pushing the plastic insert into the mating
extension tube. (Fig. 1a) Push until only small portion of insert is visible or you
cannot press any farther into the tubing. Push the extension tube assembly into
the upper handle. (Fig. 1) Insert the extension tube assembly into the lower
handle so that the tab on the plastic insert snaps into the open slot on the lower
handle. (Fig. 1b)
cannot press any farther into the tubing. Push the extension tube assembly into
the upper handle. (Fig. 1) Insert the extension tube assembly into the lower
handle so that the tab on the plastic insert snaps into the open slot on the lower
handle. (Fig. 1b)
Assembling Your Cordless Sweeper
Your cordless sweeper will require very little assembly. You should remove it from
the carton and familiarize yourself with all the components listed per the exploded
view drawing. (Pg. 2) This will help you in the assembly and operation of your
cordless sweeper.
the carton and familiarize yourself with all the components listed per the exploded
view drawing. (Pg. 2) This will help you in the assembly and operation of your
cordless sweeper.
Note:
The charging adapter will be shipped inside the packaging.
3
OPERATING INSTRUCTIONS
Note:
The lower handle extension tube has a different plastic insert. This tube
should be the first on the assembly.
2. Place the handle into the upward storage position.
Fig. 2
Charging
Light
Indicator
Charging Instructions
1.
Connect the charger plug to the charging jack or hole on the side of the sweeper.
Plug the charging adapter into the wall outlet. (120V., 60Hz.) Use only charger
Kuantech KA12D120015023U. (Fig. 2)
Plug the charging adapter into the wall outlet. (120V., 60Hz.) Use only charger
Kuantech KA12D120015023U. (Fig. 2)
4
OPERATING INSTRUCTIONS
2.
This cordless sweeper is powered by Ni-Cd batteries. Before first use, they must
be charged for a minimum 20 hours.
be charged for a minimum 20 hours.
3.
When recharging the unit, the "On/Off" switch must be in the "OFF" position.
4.
The charging light indicator on the top of the sweeper will illuminate to indicate
that the sweeper is properly charging.
that the sweeper is properly charging.
5.
To recharge, repeat step #1 above. Charging times will vary depending upon the
amount of usage between charging cycles.
amount of usage between charging cycles.
Note:
If, when you place the sweeper to recharge and the charging indicator light does
NOT illuminate, then press the On/Off button once to turn the sweeper off. The
charging indicator light should now light up.
charging indicator light should now light up.
Note:
Peak performance may only be realized after the unit has been charged and
discharged two (2) or three (3) times.
Important:
To maintain peak performance of your cordless sweeper, it is
recommended that the unit be fully discharged, then completely re-charged at least
once a month.
once a month.
Caution:
•
Use only the adaptor supplied with the sweeper.
•
Do not clean the sweeper while unit is charging.
•
Do not attempt to remove the battery pack from the unit to charge it.
•
Never attempt to throw the battery pack or unit into a fire or incinerate it.
•
Do not attempt to remove or damage the battery casing.