Справочник Пользователя для HP (Hewlett-Packard) 22A

a semicolon. You must always end a program message with one of
the three program message terminators shown in Figure 

 Use

<new line>, 

 or <new line> 

 as the program message

terminator. The word 

 means that EOI is asserted on the

HP-IB interface at the same time the preceding data byte is sent.
Most programming languages send these terminators automatically.
For example, if you use the HP BASIC OUTPUT statement, 
line> is automatically sent after your last data byte. If you are
using a PC, you can usually configure the system to send whatever

terminator you specify.

Figure 

 describes the basic syntax of SCPI subsystem commands.

As Figure 

 shows, there must be a <space> between the

last command mnemonic and the first parameter in a subsystem

command. This is one of the few places in SCPI where <space>

is required. Note that if you send more than one parameter with

a single command, you must separate adjacent parameters with a
comma. Parameter types are explained later in this subsection.

Figure 1-31 describes the syntax of common commands.