Справочник Пользователя для Nilfisk Alto 653E

9097060000(2)2009-10 A

Drive the machine on a level fl oor.

1. 

Disconnect the power supply cable (3) from the electrical 

2. 

mains.
Remove the recovery water tank retaining plate (36).

3. 

Open the recovery water tank.

4. 

If necessary, drain the water from the tank in order to make 

5. 

the fi lter visible.
Check that the pre-fi lter is clean. If necessary clean it with 

6. 

water and compressed air, then install it.
Perform steps 1, 2, 3 and 4 in the reverse order.

7. 

Disconnect the power supply cable (3) from the electrical 

1. 

mains and place it on the holder (4).
Drive the machine on a level fl oor.

2. 

Close the solution tap (A, Fig. 5) under the machine, 

3. 

behind the right rear wheel. The tap (A) is closed when it 
is in the position (B) and it is open when it is in the position 
(C).
Remove the transparent cover (D), then remove the fi lter 

4. 

strainer (E). Clean and install them on the support (F).

NOTE
The fi lter strainer (E) must be correctly positioned on 
the housing (G) of the support (F).

Open the tap (A).

5. 

Disconnect the power supply cable (3) from the electrical 

1. 

mains but do not place it on the holder (4).
Move aside the recovery water drain hose (12).

2. 

Remove the power supply cable (3) from the holder (4).

3. 

Remove the screws (A, Fig. 6) and carefully move the 

4. 

panel (B).
Check/replace the following fuse:

5. 

(C)  Electronic board fuse F1: (1 A)
Perform steps 2 to 4 in the reverse order.

6. 

P100124

P100125