Справочник Пользователя для Samsung VCC96P0H1G

 

operating the vacuum

VACUUMING WITH THE POWER BRUSH

OVERLOAD PROTECTOR 

The hose must be plugged into the canister and the 

power brush must be plugged into the hose and 

extension wand.

•  For best results, move the power brush slowly using 

short, overlapping strokes.

•  For heavily soiled areas, repeat strokes in several 

directions.

• Push the height adjustment button to match the surface being cleaned.

• Press the height adjustment button at the bottom of the wand until it clicks.

Do not invert the power brush while it is running.

You can check whether the power brush is operating correctly by lifting up the 

extension tube slightly to view the back of the brush.

The Power Brush will not operate when it is jammed or the unit is turned off.

If the Power Brush is jammed, unplug the power cord from the electrical outlet.

Turn the power brush over and remove the jammed object.

Turn the power brush back to the vacuuming position and resume vacuuming.

The overload protector shuts off the brush motor 

if the floor brush becomes obstructed. The floor 

brush will stop, but the suction motor will continue 

to run. To reset the overload protector, turn the 

vacuum off and unplug it. Clear the obstruction from 

the floor brush area. Use a pen tip to press down 

the reset switch. Turn the vacuum on and continue 

cleaning.

POWER BRUSH

DJ68-00621J-03.indb   8

13. 7. 31.   �� 11:34