Справочник Пользователя для Pelco FR85011

 

C1642M-A (1/05)

13

 

With the FT85011 transmitter/FR85011 receiver powered off, set the Data Selection switch to 
the required data communication using a small screwdriver. Refer to Table A for data commu-
nication switch settings. 

Note the following:

•

The FT85011 transmitter/FR85011 receiver allows data translation between RS-232 and 
RS-422 signal levels. Consequently, the Data Selection switch can be set to 0 (RS-232) 
on the transmitter and to 1 (RS-422) on the receiver. Conversely, the Data Selection 
switch can be set to 1 (RS-422) on the transmitter and to 0 (RS-232) on the receiver.

•

If you wish to change the data communication setting after the FT85011 transmitter/
FR85011 receiver has been powered on, power off the transmitter/receiver, change the 
data communication setting, and then power on the transmitter/receiver again.

 

The FT85011 transmitter/FR85011 receiver can be mounted into a rack or can be used as a 
standalone module. As a standalone module, the unit can be placed on a desktop or can be 
mounted to a wall.

 

As a matter of convenience, it is recommended that you set the desired data 

communication before mounting the FT85011 transmitter/FR85011 receiver. To set the 
desired data communication, refer to the 

 

 

Data Communication Switch Settings

 

RS-232

0 (default setting)

RS-422

1

RS-485 2-Wire

2

RS-485 4-Wire

3

Manchester/Bi-Phase

4

Coaxitron

5

Not used

6-9

 

C1642M-A FT85011.book  Page 13  Wednesday, January 19, 2005  12:46 PM