Справочник Пользователя для State Industries GS6 40 YOCT Series 201

25

properly. To prevent water damage, the valve must be 

properly connected to a discharge line which terminates at 

an adequate drain. Standing clear of the outlet (discharged 

water may be hot), slowly lift and release the lever handle 

on the temperature and pressure relief valve to allow the 

valve to operate freely and return to its closed position. 

See Figure 21. If the valve fails to completely reset and 

continues to release water, immediately shut off the 

manual gas control valve and the cold water inlet valve 

and call a qualified technician.

4.  Remove the outer door.
5.  Remove the two screws securing the manifold door 

assembly to the combustion chamber (Figure 23).

6.  Disconnect the thermocouple (right-hand thread), pilot 

tube, the igniter wire from the igniter button, the two 
connectors attached to the thermal switch, and manifold 
tube at the gas control valve/thermostat. (Figures  22 
& 23.) NOTE: L.P. Gas systems use reverse (left-hand) 
threads on the manifold tube. 

7.  Grasp the manifold tube and push down slightly to free the 

manifold, pilot tube, and thermocouple.

8.  Carefully remove the manifold/burner assembly from the 

burner compartment. NOTE: Be sure not to damage 
internal parts. 

1.  Take off the burner by removing the two (2) screws 

located underneath the burner.

IMPORTANT: The following maintenance procedures are 

for the FVIR System components and should be performed 

by a qualified technician.
Replacement parts may be ordered through your plumber 

or the local distributor. Parts will be shipped at prevailing 

prices and billed accordingly. When ordering replacement 

parts, always have the following information ready:
1.  model, serial, and product number

2.  type of gas

3. item 

number

4. parts 

description

See Repair Parts Section for a list of available repair parts.

1.  Turn off the gas supply to the water heater at the manual 

gas shut-off valve. This valve is typically located beside 

the water heater. Note the position of the shut-off valve in 

the open/on position then proceed to turn it off (Figure 3).

2.   On the lower front of the water heater locate the gas 

control valve/thermostat (see Figure 23). Before per-

forming any maintenance, it is important to turn the 

temperature dial on the gas control valve/thermostat to 

its lowest setting.

3.   On top of the gas control valve/thermostat turn the gas 

control knob to the “OFF” position. NOTE: On the White 

Rodgers gas control valve/thermostat the knob stop must 

first be depressed before turning the gas control knob. 

See Lighting Instructions on the water heater.(Figure 19).

• Temperature-pressure relief 

valve must comply with ANSI 
Z21.22-CSA 4.4 and ASME 
code.

•  Properly sized temperature-

pressure relief valve must be 
installed in opening provided.

•  Can result in overheating 

and excessive tank pressure.

•  Can cause serious injury or 

death.

Manually operate the temperature and pressure relief 

valve at least once a year to make sure it is working